Page 1 of 10 P/N 8007132 REV. B BJ ASA Electronics TV/VCP Floor Console Model K-9 With out Harness and Antenna 12 Volt DC powered remote controlle
P/N 8007132 Page 10 of 10 Rev. B STEP #6 REPLACE THE FACE OF THE CONSOLE ⇒ Place face of console over body of console. Gently tap into place.
P/N 8007132 Page 2 of 10 Rev. B This manual contains specific instructions on how to install this automotive TV/VCP floor console. Please read t
P/N 8007132 Page 3 of 10 Rev. B There are six (6) steps to install the K-9 TV/VCP floor console: Step # 1 Remove face of the console Step # 2 Inst
P/N 8007132 Page 4 of 10 Rev. B Step #2 Install brackets and straps 1) Mount brackets using four screws. Do not use center hole. 2
P/N 8007132 Page 5 of 10 Rev. B 3) Pre-drill 1/8” pilot holes on bottom TV shelf for strap.
P/N 8007132 Page 6 of 10 Rev. B 1) Attach both straps and customer-supplied harness, securing harness as needed.
P/N 8007132 Page 7 of 10 Rev. B Step #3 INSTALL CONSOLE TO FLOOR OF VEHICLE ⇒ BEFORE DRILLING ANY HOLES VERIFY THAT DRILL BIT WILL NOT ENTER INTO
P/N 8007132 Page 8 of 10 Rev. B STEP #4 INSTALL VCP INTO CONSOLE ⇒ Remove VCP from box. ⇒ Connect white RCA connector (customer supplied) from co
P/N 8007132 Page 9 of 10 Rev. B STEP #5 INSTALL TV INTO CONSOLE ⇒ Connect yellow RCA connector (customer supplied) to yellow RCA input jack on
Comments to this Manuals