Audiovox 9842B User Manual download pdf

Model PRO 9842B

Installation Manual

Vehicle Alarm System

With Auxiliary Output

Installation Instructions

This Unit Is Intended For Installation In Vehicles With

12 Volt Negative Ground Electrical Systems Only

Kit Contents:

(1) Control Module

(2) - Three Button Transmitters

3 Channel Code Learning Receiver

(1) - Multi Pin Input/Output Harness

(1) - Two Pin Door Lock Harness

(1) - Two Pin LED Indicator

(1) - Two Pin Valet / Programming Switch

Multi-tone Siren

(1) - Installation Manual

(1) - Operator's Manual

(1) - Limited Warranty

(2) - Window Decals

Released 11-9-01.

Changed 1-23-02.(note: No Rev was Required)

Corrected 2-15-02.(note: No Rev was Required)

Revision C: 3-5-03 Removed Channel # reference from title

Revised: REV. A 1-21-03 (Corrected page 8, Wiring Diagram)

Revised: REV. B 1-30-03 (Corrected Blue wire from Channel 3 to Channel 2)

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - Installation Instructions

1Model PRO 9842BInstallation ManualVehicle Alarm SystemWith Auxiliary OutputInstallation InstructionsThis Unit Is Intended For Installation In Vehicle

Page 2

The PRO 9842B Vehicle Alarm System is designed to provide a basic deterrent to vehicle theft, and a convenientelectronic means to gain access to the v

Page 3

33HOOD AND TRUNK PIN SWITCHES:The pin switch included in this package is intended for protecting the hood or trunk/hatch areas of the vehicle. Inall

Page 4

4cases the factory door pin-switches are wired in parallel, making it necessary to connect to only one door switchin order to detect the opening of al

Page 5 - Green Unlock Ground (-)

55+12VDC source. Connect the common, normally open, and normally closed contacts of the relay to perform theselected function of Channel 3.DOOR LOCK/

Page 6

6OPTIONAL SHOCK SENSOR4-PIN White Plug w/4 Wires; Red, Black, Blue, and GreenThe Red (+12 volt), Black (ground), Blue (pre-detect) and Green (full tri

Page 7

77once you have toggled past it. Should you accidentally toggle past the feature you wanted to program, you must exitand re-enter the Programming Mode

Page 8 - 128-6189C