Model AA-RS30CSInstallation ManualThis Unit is Intended for Installation in Vehicles with12 Volt Negative Ground Electrical Systems,Gasoline or Diesel
10disarm a factory theft deterrent system to prevent false triggering of the factory alarm when the remote start unitengages or when the AA-RS30CS is
11Entry Illumination DetailGreen w/Black Trace Wire: 300mA Latched Channel 3 OutputThe Green w/Black Trace wire supplies a 300mA switched output wh
12NOTE:1. When selecting Diesel operation, (Feature Nine), over gasoline, the only change is to the ignition circuits. WhenDiesel is selected, the ig
131 Flash 10 or 15 Minute Run Timer Expired2 Flashes Low or No Tach Signal (RPM)3 Flashes Positive Or Negative Shutdown Wire Activated4 Flashes Contro
14TESTING YOUR INSTALLATION:WARNING!!The following procedure must be performed after the installation of an Audiovox Remote Start Device. Itis the re
15necessary to reconfigure the Remote Starts Wiring to accommodate this vehicle. The information concerning theMechanical Neutral Safety Switch provid
16KEY IN SENSOR CIRCUITS:If the vehicle you are working on does not have or you cannot locate the ECM reference wire, there are two alternativesavaila
17METHOD 2G. Connect terminal 87 of the relay to the Chime Module side of the previously cut wire in step D.H. Connect terminal 85 of the relay to the
18COMPLETING THE INSTALLATION:After you have confirmed the operation of the Audiovox Remote Start unit and tested all the safety features of thesystem
19WIRING DIAGRAM
The AA-RS30CS is Remote Start/Keyless Entry System is designed to be used with Automatic Transmission VehiclesOnly! The unit provides a selectable ig
© 2000 Audiovox Electronics Corp. , Hauppauge N.Y. 11788 128-5818
3Drill a 1/4" hole in the desired location and mount the switch by passing it through the panel from the underside.Secure the switch using the nu
SEE NEUTRAL START SAFETY TEST FOR FURTHER DETAILS.4BLUE Wire: Ignition 1 OutputConnect this wire to the ignition 1 wire from the ignition switch. Th
WIRING CONNECTIONS: 12 Pin Input / Output HarnessBlack Wire: Chassis Ground SourceConnect the Black wire to a known vehicle ground source or to a sol
connect the Brown w/Black trace wire to the output of the brake light switch. If the brake light switch in the vehicleswitches ground, do not use the
LIGHT BLUE Wire: Ignition 3 / Shock Disable OutputThis wire provides a 300mA ground output that becomes active 3 seconds before the Remote Start Unit
8DARK GREEN/ORANGE Wire: Tach Sensor InputThis wire will continually monitor the engine tach rate while the unit is under power of the Remote Start m
9The Green wire of the two pin harness provides a ground pulse during the disarming sequence, or pulsed groundunlock output. Connect the Green wire t
Comments to this Manuals