Model APS 685Installation Manual4 Channel Remote Start / Keyless Entry SystemInstallation InstructionsThis Unit Is Intended For Installation In Vehicl
3 Wire Positive Switched 2 Step Door LocksThe green wire provides a positive pulse during locking, or the pulsed + 12 volt lock output. Connectthe gre
3 Wire Positive Switched Door Locks:In this application, the Red wire of the door lock harness provides a + 12 volt pulse during the unlockingsequenc
Black w/ Yellow Trace Wire: Ground Output During Start (Crank)The Black w/ Yellow Trace wire will provide a 300 mA ground output while the starter ou
Dark Blue/Black and Green/White - 2 Pin Input/Output Harness:Dark Blue/Black Trace Wire: External Trigger InputThe Dark Blue/Black trace wire allows t
5. Use channel one button on the transmitter to advance to the feature that you want to change. EXAMPLEIf you need to change programmable feature nu
TIMED START PROGRAM:The Remote Start unit has the ability to start the vehicle automatically at timed intervals. This feature isuseful in extremely c
1. With the driver's window in the down position, start the vehicle using the RF transmitter.2. Reach inside the car and pull the hood release.3.
CAUTION!REMEMBER TO RECONNECT THE BROWN/BLACK WIRE TEMPORARILYDISCONNECTED IN STEP 3DO NOT RELEASE THIS VEHICLE TO THE CONSUMER UNTIL YOU CONFIRM THE
KEY IN SENSOR CIRCUITS:If the vehicle you are working on does not have or you cannot locate the ECM reference wire, there aretwo alternatives availabl
mote Start Unit as shown below.METHOD 2To connect to the key in sensor circuit as shown for method 2:A. Locate the control wire that connects the driv
The APS-685 Remote Start/Keyless Entry System is designed to be used with Automatic Transmission VehiclesOnly! The unit provides a selectable ignitio
WIRING DIAGRAM© 2000 Audiovox Electronics Corp., Hauppauge, N.Y. 11788 128-5861A
Drill a 1/4" hole in the desired location and mount the switch by passing it through the panel from theunderside. Secure the switch using the nu
NOTE: This wire must be connected to the vehicle side of the starter cut relay (if present). For theelectrical neutral switch configuration, this con
WIRING CONNECTIONS: 12 Pin Input / Output HarnessBlack Wire: Chassis Ground SourceConnect the Black wire to a known vehicle ground source or to a sol
BROWN w/ BLACK Tracer Wire: Positive Inhibit Input 2Any time + 12 Volts is applied to the Brown w/ Black tracer wire, the Remote Starter will stop ope
LIGHT BLUE Wire: Ignition 3 / Shock Disable OutputThis wire provides a 300mA ground output that becomes active 3 seconds before the Remote Start Unit
General Motors VATS By-Pass DiagramDARK GREEN/ORANGE Wire: Tach Sensor InputThis wire will continually monitor the engine tach rate while the unit is
3 Wire Ground Switched 2 Step Door LocksIn this application, the red wire provides a ground pulse during locking, or the pulsed ground lock output.Con
Comments to this Manuals