128-77601 of 161Model AS 9076Installation ManualRemote Start Upgrade ModuleInstallation InstructionsThis Unit Is Intended For Installation In Vehicle
128-776010 of 1610This Remote Car Starter will learn the tach rate of most vehicles single ignition coils, multiple coil packs, and or singleinjector.
128-776011 of 1611Multi Coil Pack Adaptor: (Optional)The multi coil pack adaptor is designed for use with vehicles having multiple ignition coils wher
128-776012 of 1612TESTING YOUR INSTALLATION:CAUTION!! The following procedure must be performed after the installation of an Audiovox Remote StartDevi
128-776013 of 1613this vehicle. The information concerning the Mechanical Neutral Safety Switch provided below will helpyou to determine if the vehicl
128-776014 of 1614circuits may be used only if the above circuit is not available.NOTE: When completing an installation using either of the following
128-776015 of 1615C. Locate the key in sensor switch wire that connects the chime module to the ignition cylinder .D. Cut this wire and connect the ig
128-776016 of 1616© 2006 Audiovox Electronics Corp., Hauppauge, N.Y. 11788 128-7760
128-77602 of 162This Remote Start/Keyless Entry Upgrade System is designed to be used with Automatic TransmissionVehicles Only! The unit provides a s
128-77603 of 163WIRING THE 6 PIN MAIN POWER HARNESS:Note: Do not remove the fuse holders from this wire harness. Fuses must beused and located as cl
128-77604 of 164SEE NEUTRAL START SAFETY TEST FOR FURTHER DETAILS.BLUE Wire: Ignition 1 OutputConnect this wire to the ignition 1 wire from the ignit
128-77605 of 165the Black w/ White wire is at open circuit through the control switch, the remote starter is disabled.Connect the Black w/ White trace
128-77606 of 166This wire should be connected to the ignition input of the alarm system.The Yellow w/ Black wire output will allow you to remote start
128-77607 of 167NOTE: These wires are typically White w/ Black trace and Violet w/ Yellow trace, however in later modelCadillacs, they are run through
128-77608 of 168Tachometer Input Wiring DetailWIRING THE 4 PIN AUXILIARY OUTPUT HARNESSThe auxiliary 4 pin connector provides low current outputs to c
128-77609 of 1691. Programmable Features:Feature Lts Flash 1X Lts Flash 2X Lts Flash 3X Lts Flash 4X Default1 Run Time 5 Min. 10 Min. 15Min
Comments to this Manuals