Audiovox Prestige APS-900 User Manual

128-82101 of 161Kit Contents(1) - Control Module(2) - 1 Button High Frequency Transmitters(1) - 1 Channel Code Learning Receiver(1) - Multi Pin Input/

128-821010 of 16104. Immediately turn the ignition key OFF.5. Hold the program push-button switch ON, then start the vehicle using the ignition key.

128-821011 of 1611To test the integrity of this circuit:1. With the driver's window in the down position, start the vehicle using the RF transmit

128-821012 of 1612MECHANICAL NEUTRAL SAFETY SWITCH CONSIDERATIONS:Mechanical neutral safety switch configurations differ slightly in that they do not

128-821013 of 1613These situations should be carefully considered before altering the vehicle's wiring and must be fully explained to theconsumer

128-821014 of 1614NOTE: A second 4002 series diode may be required to maintain the integrity of the hood open, shut down circuit. Ifthis is the case,

128-821015 of 1615

128-821016 of 1616© 2007 Audiovox Electronics Corp., Hauppauge, NY 11788 128-210

128-82102 of 162This Remote Start System is designed for use with Automatic Transmission Vehicles Only! The unit provides waitto start input for glow

128-82103 of 163THE RECEIVER/ANTENNA ASSEMBLY:The Superheterodyne Receiver Antenna Assembly provided with this unit allows routing from below the dash

128-82104 of 164NOTE: This wire must be connected to the vehicle side of the starter cut relay (when used). For the electrical neutralswitch configur

128-82105 of 165NOTE: See programming information concerning this wire to allow output during the "START" mode.VIOLET WIRE: Accessory Output

128-82106 of 166BROWN w/ BLACK Tracer Wire: Positive Inhibit Input 2Any time + 12 Volts is applied to the Brown w/ Black tracer wire, the Remote Start

128-82107 of 167LIGHT BLUE Wire: Ignition 3 / Shock Disable OutputThis wire provides a 300mA ground output that becomes active 3 seconds before the Re

128-82108 of 168DARK GREEN Wire: Tach Sensor InputThis wire will continually monitor the engine tach rate while the unit is under power of the Remote

128-82109 of 169NOTE: The outputs above are low current outputs and must be used with a relay if the circuit's requirement ismore than 300 mA.2 P