Audiovox Prestige 128-7852A User Manual

Browse online or download User Manual for Sensors Audiovox Prestige 128-7852A. Audiovox Prestige 128-7852A User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 10
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
128-7852A
1 of 10
Model APS-920
Owners Manual
ARMING THE SYSTEM - ACTIVE
1. Turn off the engine, exit the vehicle, and close all doors,
hood lid and trunk lid.
2. Press and release Lock/Arm button on the keychain
transmitter.
The dash mounted LED begins to flash slowly. Parking
Lights flash one time.
Siren sounds one chirp.
If the siren/horn
sounds 3 chirps, then you have left a door,
trunk, or hood lid ajar. Simply close the opened entry point
to provide full protection. If the siren "chirped" three times,
sometime after arming, the exclusive, patented, delayed dome light
learn circuit has been programmed and the system detected a open
entry point after the learned delay expired. Again, closing the hood,
trunk, or doors will correct the problem and you do not need to dis-
arm the system to make the correction. If the siren/horn did not
sound when arming, then the chirps have been turned off and you should refer to the
section titled "ELIMINATING THE ARM/DISARM CHIRPS" in this manual.
NOTE: If selectable feature 9, Chirp Delete From Transmitter, was set to the on position
during installation, then you can selectively defeat the arm & disarm chirps by holding
the transmitters Lock or Unlock button for about 2 seconds.
Note: If Passive Arm Mode was selected on during installation, then 30 seconds after
the last vehicle door is closed, the unit will arm automatically.
PROTECTION WHILE THE SYSTEM IS ARMED
Opening any protected door, hood or trunk lid will cause the alarm to immediately sound. The
alarm will continue to sound for 30 seconds, then stop and continue to monitor all protected entry
points. If the thief left a door opened, the alarm will sound for six 30 second cycles, remain armed
and ignore that triggered zone.\
Whenever the system is armed, the dash mounted LED indicator will slowly flash. This serves as
a visual deterrent to the potential thief. The LED is a very low current bulb and will not cause the
vehicle’s battery to drain, even when left unattended for extended periods.
Whenever the system is triggered, the vehicle’s parking lights will flash for the full 30 second
alarm cycle, attracting visual attention to the vehicle.
Optional - Whenever the system is armed, the vehicle’s starting circuit will be bypassed. If the thief
should choose to ignore the siren, the vehicle can not be started.
Any mild impact to the vehicle’s glass will cause the alarm to sound a short series of warning
tones.
Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30 second alarm
cycle.
NOTE: If the optional interior illumination circuit was installed, the interior light will flash as well
for the full 30 second alarm cycle.
DISARMING THE SYSTEM
1. As you approach the vehicle, press and release the Unlock/Disarm button on the keychain
transmitter.
The dash mounted LED turns off. If passive arming is selected on, the LED will start flashing
rapidly, indicating that the system is re-arming automatically. Open any door to suspend the
automatic arming. Parking Lights flash two times. If the parking lights flashed three times,
then the alarm was triggered in your absence. Before turning the key on, examine the LED to
identify which zone was triggered. Siren sounds two chirps. If the siren sounds 4 chirps, then
the alarm was triggered in your absence. Before turning the key on, examine the LED and refer
to the INTRUSION WARNING SIGNALS section of this manual to identify which zone was
triggered.
If the siren did not sound when disarming, then the chirps have been turned off
and you should refer to the section titled “ELIMINATING THE ARM / DISARM CHIRPS“ in this
manual.
Doors Unlock - Optional
NOTE: If the optional Interior illumination feature has been added as an added convenience, the
system will turn on the interior lights when the system is disarmed.
Rev A: Remove warranty from manual. 6/07
Page view 0
1 2 3 4 5 6 7 8 9 10

Summary of Contents

Page 1 - Model APS-920

128-7852A1 of 10Model APS-920Owner’s ManualARMING THE SYSTEM - ACTIVE1. Turn off the engine, exit the vehicle, and close all doors,hood lid and trunk

Page 2

128-7852A10 of 10ORDER FORM FOR APS620CF & APS920CF21) Transmitter Model Number_____________________2) Name: __________________________________

Page 3

128-7852A2 of 10WHILE THE SYSTEM IS SOUNDINGIf during a triggered state, you wish to shut off the siren without disarming your security system,simply

Page 4

128-7852A3 of 10If the new code was accepted, the unit will report back the newly entered code, by flashing theLED, first indicating the 10ths digit,

Page 5

128-7852A4 of 10characters hanging about your vehicle. To access this mode, while within range of your car, simply pressand hold either the lock or u

Page 6

128-7852A5 of 10button for two seconds. If you find the normal arming and disarming chirps annoying, they canbe turned off permanently, eliminating th

Page 7

128-7852A6 of 10the device indicated, momentarily press, or press and hold the appropriate transmit-ter button(s) as indicated above.TURBO TIMER MODET

Page 8

128-7852A7 of 101) Enter the transmitter program mode of channel 1 as indicated above.2) Press and hold any transmitter button that has not been progr

Page 9

128-7852A8 of 10Vehicle as Been Started By Remote Control.Vehicle Is Running Under Control of The Remote Start Unit.Battery Save Mode Is On.Battery Le

Page 10 - 10 of 10

128-7852A9 of 10CAUTION!!CARBON MONOXIDE GAS CAN CAUSE SERIOUS INJURY AND EVEN DEATHIt is the sole responsibility of the user to operate the vehicle t

Comments to this Manuals

No comments