Audiovox PEQ-200 Owner's Manual download pdf (Page 16)

100

12 En

Connections

■ Connecting speaker cables

1 Remove approximately 10 mm (0.4 in) of

insulation from the end of each speaker

cable and then twist bare wires of the cable

together so that they will not cause a short

circuits.

2 Loosen the knob, insert the twisted bare

wires into the hole and then tighten the knob.

■ Using bi-amplification connections

If you do not connect surround back speakers, you can use

the SURROUND BACK/BI-AMP jacks to make bi-

amplification connections to one speaker system which

supports bi-amplification connection as shown below.

To activate the connections, set “BI-AMP” to “ON” in the

advanced setup menu (page 63).

Note

• You cannot use surround back speakers or extra speakers (presence and

Zone2 speakers) when bi-amplification connections are made.

Caution

• A speaker cable is a pair of insulated cables running side by side in general. One of the cables is colored differently

or striped to indicate a polarity. Connect one end of the colored/striped cable to the “+” (red) terminal of this unit

and the other end to that of your speaker, and connect one end of the other cable to the “–” (black) terminal of this

unit and the other end to that of your speaker.

• Before connecting the speakers, be sure to disconnect the power cable.

• Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or

speakers. If the circuit shorts out, “CHECK SP WIRES!” appears on the front panel display when this unit is turned

on.

• If images on the monitor (CRT) are distorted, place the speakers away from the video monitor.

• Use speakers with an impedance of 6-ohm or larger. Set speaker impedance in the advanced setup menu before

connecting the speakers (page 63). You can also use 4-ohm speakers as the front speakers when you set “SP IMP.” to

“6ΩMIN”.

Connecting the banana plug (Except Korea,

U.K., Europe, Russia and Asia models)

Tighten the knob and then insert the banana plug into

the end of the terminal.

10 mm (0.4 in)

Red: positive (+)

Black: negative (–)

Banana plug

Caution

Before making bi-amplification connections, remove

any brackets or cables that connect a woofer with a

tweeter. Refer to the instruction manuals of speakers for

details.

When not making bi-amplification connections, make

sure that the brackets or cables are connected before

connecting the speaker cables.

SURROUND BACK/

BI-AMP

FRONT

Front speakers

Right Left

This unit

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 99 100

Comments to this Manuals

No comments

Audiovox PEQ-200 Owner's Manual Page 16

Comments to this Manuals

Related products and manuals for AV receivers Audiovox PEQ-200