Audiovox Prestige 128-8146 User Manual download pdf

Page 1

128-8146

1 of 8

Model APS-520

Owner’s Manual

ARMING THE SYSTEM - ACTIVE

1. Turn off the engine, exit the vehicle, and close all doors, hood lid

and trunk lid.

2. Press and release Lock/Arm button on the keychain transmitter.

The dash mounted LED begins to flash slowly. Parking Lights flash

one time.

Siren sounds one chirp.

If the siren/horn sounds 3 chirps, then you have left a door, trunk,

or hood lid ajar. Simply close the opened entry point to provide full

protection. If the siren "chirped" three times, sometime after arm-

ing, the exclusive, patented, delayed dome light learn circuit has

been programmed and the system detected a open entry point after the

learned delay expired. Again, closing the hood, trunk, or doors will correct

the problem and you do not need to disarm the system to make the correction.

If the siren/horn did not sound when arming, then the chirps have been

turned off and you should refer to the section titled "ELIMINATING THE ARM/

DISARM CHIRPS" in this manual.

NOTE: If selectable feature 9, Chirp Delete From Transmitter, was set to the on position during

installation, then you can selectively defeat the arm & disarm chirps by holding the transmitters Lock

or Unlock button for about 2 seconds.

Note: If Passive Arm Mode was selected on during installation, then 30 seconds after the last

vehicle door is closed, the unit will arm automatically.

PROTECTION WHILE THE SYSTEM IS ARMED

Opening any protected door, hood or trunk lid will cause the alarm to immediately sound. The alarm will

continue to sound for 30 seconds, then stop and continue to monitor all protected entry points. If the thief left

a door opened, the alarm will sound for six 30 second cycles, remain armed and ignore that triggered zone.\

Whenever the system is armed, the dash mounted LED indicator will slowly flash. This serves as a visual

deterrent to the potential thief. The LED is a very low current bulb and will not cause the vehicle’s battery to

drain, even when left unattended for extended periods.

Whenever the system is triggered, the vehicle’s parking lights will flash for the full 30 second alarm cycle,

attracting visual attention to the vehicle.

Optional - Whenever the system is armed, the vehicle’s starting circuit will be bypassed. If the thief should

choose to ignore the siren, the vehicle can not be started.

Any mild impact to the vehicle’s glass will cause the alarm to sound a short series of warning tones.

Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30 second alarm cycle.

NOTE: If the optional interior illumination circuit was installed, the interior light will flash as well for the full 30

second alarm cycle.

DISARMING THE SYSTEM

1. As you approach the vehicle, press and release the Unlock/Disarm button on the keychain transmitter.

The dash mounted LED turns off. If passive arming is selected on, the LED will start flashing rapidly, indicating

that the system is re-arming automatically. Open any door to suspend the automatic arming. Parking Lights flash

two times. If the parking lights flashed three times, then the alarm was triggered in your absence. Before

turning the key on, examine the LED to identify which zone was triggered. Siren sounds two chirps. If the

siren sounds 4 chirps, then the alarm was triggered in your absence. Before turning the key on, examine the

LED and refer to the INTRUSION WARNING SIGNALS section of this manual to identify which zone was

triggered.

If the siren did not sound when disarming, then the chirps have been turned off

and you should refer to the section titled “ELIMINATING THE ARM / DISARM CHIRPS“ in this manual.

Doors Unlock - Optional

NOTE: If the optional Interior illumination feature has been added as an added convenience, the system will

turn on the interior lights when the system is disarmed.

WHILE THE SYSTEM IS SOUNDING

If during a triggered state, you wish to shut off the siren without disarming your security system, simply press

and release any transmitter button other than the Unlock/Disarm button. This action will turn off the siren yet

leave the vehicle fully armed and protected. This feature is particularly useful if you are aware of children

playing near your vehicle that may accidently trigger your security system. In this case you can cancel the

siren sounding without disarming your alarm.

INTRUSION WARNING SIGNALS

This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If an

1 2 3 4 5 6 7 8

Model APS-520 1
128-8146 2

Summary of Contents

Page 1 - Model APS-520

Page 1128-81461 of 8Model APS-520Owner’s ManualARMING THE SYSTEM - ACTIVE1. Turn off the engine, exit the vehicle, and close all doors, hood lidand t

Page 2 - 128-8146

128-81462 of 8Page 2intrusion attempt has occurred, the siren will chirp 4 times and the parking lights will flash 3 times whendisarming the system.

Page 3

Page 3128-81463 of 82. Turn the ignition switch to the on position.3. Within 10 seconds, press and release the valet/override switch, 3 times.4. Withi

Page 4

128-81464 of 8Page 4that can be selected by the operator:1. Normal Operation (default mode) In this mode, any strong vibrations will cause the sirento

Page 5

Page 5128-81465 of 82) Press and release the pushbutton switch three timesThe unit will flash the parking lights and or beep the horn once to indicate

Page 6

128-81466 of 8Page 6FEATURES AND FUNCTIONS OF YOUR TWO WAY LCD 920TX2Doors are locked Icon. If the system is armed “ ARM “ will also appear below t

Page 7

Page 7128-81467 of 8Credit card purchasers can order additional or replacementtransmitters by phone. Simply dial 1 - 800 - 645 - 4994, andfollow the

Page 8