6
VEHICLE PREPARATION
1) Read the manuals and get familiar with the electrical requirements and
connections.
2) Prepare the vehicle by removing any interior trim necessary to gain access to the
vehicle's wiring as well as all areas where interconnecting wire harnesses will be
located. The mounting method and the location will vary from vehicle to vehicle, so
this manual will only focus on the installation of the Master and Satellite Monitors in
the supplied configuration. The best location for the HR7011PKG System
components are:
a. Monitors: Vehicle-specific Headrest
The Master Monitor should be installed in the passenger position most
used.
b. Wireless FM Interface Box: Under either seat where monitors are located.
Note:
3) Locate an accessory power source (+12 VDC present when the
ignition key is in the accessory and run positions. 0 VDC should be present
when the ignition key is in the OFF position) and a good ground. Generally,
these wires can be located at the ignition switch or fusebox.
Ensure that the switched power is fused at the source. Failure to do so
may result in vehicle wiring damage.
4) Run the wiring harnesses throughout the vehicle as necessary. (Refer to the
Wiring Diagrams on page 10, as well as the wiring instructions for the individual
components and accessory options being installed). Be sure that all the wiring
is protected from sharp edges and is routed in such a manner that it will not be
pinched when it is fully installed. Be sure to leave enough slack in the wiring at
each component to allow sufficient working room. Be sure to leave enough
slack in the monitor cables to allow the headrest to move up or down, and the
seat to move backward and forward.
5) Remove all the components from their packaging and then place them in the
vehicle at their respective locations.
6) Install the Headrests:
a. Remove the vehicle's original Headrests.
b. Hold the Headrest above the seat and insert the two cables into the headrest
support tube holes. Make sure that the headrest is in the correct position
(Display facing the rear).
c. Route the cables through the seat back and out the bottom of the seat.
d. Place the Headrest support tubes into the support tube holes while pulling
the cables to remove the slack. Be sure to leave enough slack in the monitor
cables to allow the headrest to move up or down.
should be
Note:
(3 pages)
(23 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals