Audiovox DST 961 User Manual download pdf (Page 14)

IN CASE OF DIFFICULTY

years. Clean it only with a sofLcloth slightly

dampened with water or a mild soap. Do

not use excess water or cleaning solvents

of any kind.

Remember that eiectriccii appiiances can

cause serious injury if used when you are

wet or standing in water, DO NOT

RETRIEVE IT UNTIL YOU UNPLUG THE

POWER CORD AND TELEPHONE LINE

CORDS FROM THE WALL. Then pull the

unit out“’9 unplugged cords.

ou have difficulty operating your phone,

ti. suggestions below should solve the

problem. If you still have difficulty after trying

these suggestions call Audiovox

Communications at 1-800-229-1235.

THE PHONE DOESN WORK AT ALL _

* Make sure the power cord is plugged in.

* Make sure the telephone line cord is plugged

firmly into the base unit and the telephone

wall jack.

* Make sure the batteries are properly

charged. If the MLiTE/LOW ВАТТ LED is

flashing, the battery pack needs charging.

NO DIAL TONE

First check all the suggestions above. If

you still don hear a dial tone, disconnect

the base unit from the telephone jack and

connect a different phone. If there is no dial

tone on that phone either, the problem is in

your wiring or local service. Call your local

telephone company.

YOU GET NOISE, STATIC, OR A WEAK

SIGNAL EVEN WHEN YOU E NEAR

• THE BASE UNIT.

Household appliances plugged into the

same circuit as the base unit can sometimes

cause interference. Trv mnving the appli

? or the base unit to another outlet.

VoU GET NOISE, STATIC, OR A WEAK

SIGNAL WHEN YOU E AWAY FROM

THE BASE UNIT.

* You may be out of range. Either move

close to the base, or relocate the base

unit.

* The layout of your home may be limiting

the range. Try moving the base unit to

another position.

THE HANDSET DOES NOT RING

WHEN YOU RECEIVE A CALL.

Make sure you have the handset ringer

activated. To set the ringer see page

PROGRAMMING THE RINGER on page

19.

* Make sure the telephone line cord is

plugged firmly into the base unit and the

telephone jack. Make sure the power

cord is plugged in.

* You may be too far from the base unit.

* You may have too many extension

phones on your telephone line to allow

all of them to ring. Try unplugging some

of the other phones.

YOU HEAR OTHER CALLS WHILE

USING YOUR PHONE.

Disconnect your base unit from the

telephone jack, and plug in a regular

telephone. If you still hear other calls, the

problem is probably in your wiring or local

service. Call your local telephone company.

YOU HEAR NOISE IN THE HANDSET,

AND NONE OF THE KEYS OR

BUTTONS WORK.

Make sure the power cord is plugged in.

COMMON CURE FOR ELECTRIC

_ EQUIPMENT

Electronics, like people, can sometimes

get confused. If the unit does not seem to

be responding normally, then try putting the

handset in the cradle, if it does not seem to

respond after trying this a few times, do the

following (in the order listed);

1. Disconnect the power to the base.

2.. Disconnect the handset battery.

3. Wait a few minutes.

1 2 ... 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments