Audiovox XMB10 User Manual download pdf (Page 6)

128-7546

6 of 16

-6-

is also located on the front panel. When the Xpress

Receiver is installed in the boom box, the

1.PHONES Jack: Accepts a stereo headphone jack

to provide private listening capability for the Boom

Box.

2. AUX Jack: Accepts an audio input signal from an

external audio device. When using the AUX audio

input, turn the Receiver off to preserve battery power.

Adjust the volume level of the external audio device

to obtain an audio output from the XMB10. The

volume control on theexternal audio device

should be set to mid-range.

3.VOLUME +/- Pushbuttons: Increase or decrease

the volume of the audio output signal from the

XMB10. Toincrease the

volume level, press

the + pushbutton; to

decrease the volume

level, press the

- pushbutton.

NOTE: The Volume buttons on the Remote Control

unit (included w/Receiver Combo) will also

control the volume output of the Boom Box.

4.Power On/Status/Low Battery LED: The LED

lights bluewhen the Power On/Off pushbutton is

pressed to apply power to the XMB10. When

operating on AC current, the LED will briefly flash

approximately every 10 seconds. When operating

on DC(batteries) current, the LED will briefly flash

approximately every 5 seconds.

The LED will also indicate the status of the

volume pushbuttons when the AUX Jack is in use;

the LED will flash each time the Volume + or -

button is pressed until the maximum setting is

reached in eitherdirection. Then the LED will

resume power source flashing as before.

5.Power On/Off Switch: When pressed, applies

powerto the Boom Box; the power on LED

indicator (4) lights blue.

6. EJECT Button: Press this button to release the

spring-loaded XMB10 mounting plate to install and

remove the Xpress

Receiver from the Boom Box.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments

Audiovox XMB10 User Manual Page 6

Comments to this Manuals

Related products and manuals for Home audio sets Audiovox XMB10