Audiovox 50-0311x-015 Series User Manual download pdf (Page 3)

I. PREPARATION OF VEHICLE INTERIOR

1. Remove and retain (3) three screws which secure

dome light in place. See Figure 1.

2. Disconnect wiring and lay light in a safe place.

3. Using O.E. console as a reference, carefully

measure and trim headliner as shown. Caution:

Before cutting headliner material, check for

wiring or other componentry above headliner.

Cut only where indicated. DO NOT OVERCUT

HEADLINER. Make sure that the 7 1/2" cut is

centered left to right in vehicle. See Figure 2.

4. If speaker upgrade kit was purchased, trim these (*)

locations. See Figure 2.

5. Construct a jumper harness that will connect the

vehicle’s dome light wires to the lights in video

system. Connect the white wire from video system

to the O.E. pink/blue wire. Connect the black wire

from video system to the chassis ground.

See Figure 3.

6. Using a test light, check function of lights.

7. Install O.E. dome light in original manner.

FIGURE 1

FIGURE 2

FIGURE 3

1 2 3 4 5

No comments

Audiovox 50-0311x-015 Series User Manual Page 3