Audiovox AXT-1200 User Manual Page 1

OWNER'SMANUALModel AXT-12001200 Watt Bridgeable2-Channel MOSFET Amplifier

-10-3125OPERATION46HI-INPUTHI-INPUTGNDGNDL +L + R +R +LL RRRRLLPWRPWRPRTPRTMINMINMAXMAXGAINGAIN0dB0dB18dB18dB50Hz50Hz250Hz250HzLPFLPF50Hz50Hz250Hz250H

-11-High Level Input ConnectionIf the car stereo not does not provide low-level outputs, the amplifier may be connected via the speaker (high-level) o

9-12-FuseThe circuitry of the amplifier is protected from damage byan automotive-type fast-blow fuse. If fuse replacementis necessary, use only fuses

AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof,under normal

2003 Audiovox Electronics Corporation, Hauppauge, N.Y.CCPrinted in Korea128-6565

INDEXSpecifications...3Precautions...

Input Impedance: Low-level 10K OhmsHigh-level 100 OhmsInput Sensitivity: Low-level 200 mV - 8 V.High-level 2V - 10 V.Filter type: Selectable High/Ful

1. Although this unit is designed with built-in self-protection circuits, there may be a possibility of damage if it is not wiredcorrectly. Please fol

1. Select a mounting area where the amplifier willhave sufficient air circulation for proper cooling.Inadequate air circulation will cause the tempera

The wiring of your amplifier will depend on the system and speakers you are using but will either be a stereo, mono, ormixed-mono application. The fol

4. Speaker ConnectionsDepending on the type and number of speakers used with the amplifier, wire them to the speaker terminals as per the appropriate

-8-USE EITHER HIGH-LEVEL ORLOW-LEVEL INPUT, NOT BOTH.IMPORTANTRCA TYPESHIELED CABLES(NOT INCLUDED)Right LOW-LEVELRCA OUTPUTSCAR STEREOINPUT WIRING DIA

-9-CAR STEREOGROUNDBATTERYFOR 12 VOLT USE ONLYAUTO-ANTENNA LEADGROUND METALSECTION OF VEHICLEEXISTING SCREW OR BOLT CLEAN PAINT, RUST, DIRTOR GREASE F