128-7853A1 of 161Model APS-920Installation ManualThis Remote Start/Alarm System is designed to be used withAutomatic Transmission-Fuel Injection Vehi
128-7853A10 of 1610The Light Blue wire can be used to accommodate the following situations:A. Shock Sensor By Pass:B. Additional Ignition Output:C. GM
128-7853A11 of 16114 Pin Shock Sensor Connector “D”Red, Black Green & Blue wires of the shock sensor harness provide +12 Volts, Ground, FullTrigge
128-7853A12 of 1612
128-7853A13 of 16133 Wire Positive Switched Door Lock Circuits:In this application, the Red wire of the 2 pin harness provides a Positive pulse during
128-7853A14 of 1614Setting Up The System Programming Features:Bank 1 Transmitter ChannelsStart with the system disarmed, tun the ignition switch to th
128-7853A15 of 1615Programming Tach Rate:NOTE: All applications require that tach be programmed.The unit will not operate unless tach is programmed.
128-7853A16 of 16163. Within 10 seconds of the key turning off, cycle the enable switch Off, On, Off, On ( 2 times) toselect a 2 hour timed start inte
128-7853A2 of 162INSTALLATION OF THE MAJOR COMPONENTS:CONTROL MODULE:Select a mounting location inside the passenger compartment (up behind the dashbo
128-7853A3 of 163SIREN:Select a location in the engine compartment that is not accessible from below the vehicle. Theselected location must be clear
128-7853A4 of 164DO NOT PLUG THE SIX PIN MAIN POWER HARNESS OR THE MULTI PIN INPUT/OUTPUTHARNESS INTO THE CONTROL MODULE UNTIL ALL CONNECTIONS TO THE
128-7853A5 of 165BLUE Wire: Ignition 1 OutputConnect this wire to the ignition 1 wire from the ignition switch. This wire will show +12 voltswhen th
128-7853A6 of 166false triggering of the factory alarm when the remote start unit engages or when the transmitteris used to unlock the doors.NOTE: Th
128-7853A7 of 167Orange: Ground While Armed OutputThis wire provides a 300 mA ground output when the alarm circuit is armed to control thestarter inhi
128-7853A8 of 168Brown Wire: Negative Door TriggerIf the vehicle's door courtesy light switches ground when the door is opened, (Most GMs andImp
128-7853A9 of 169Green/Yellow Wire: DIESEL WAIT TO START INPUTThe green/yellow wire, when connected to the wire that get + 12 volts during the glow p
Comments to this Manuals