Audiovox MZ7TFT Specifications download pdf (Page 3)

MZ7TFT

Wiring

1. Align the ridges on either end of the combined input cable (VIDEO IN,

AUDIO L, AUDIO R, REAR TS, GROUND and ACC) and connect the

cable to the male connector on the back of the MZ7TFT. The connector

will only fit when the notched areas are properly aligned.

2. Connect the REAR TS connector to the MZ7-TFT connector on the back

of your compatible head unit (if applicable).

NOTE: You can connect up to three monitors to your compatible head

unit using the Touch Screen Expansion Module (included). See “Touch

Screen Expansion Module” on page 4 for instructions.

3. Connect the AUDIO R, AUDIO L and VIDEO IN connectors to the Video

and Audio output (Headphone Multizone) cables on the back of your

compatible head unit or to another auxiliary device for which you would

like to output video.

4. Connect the black GROUND wire to the factory ground wire on your head

unit, or to a clean, unpainted metal part of the automobile chassis using a

ring terminal and a sheet metal screw.

5. Connect the ACC wire to the factory accessory or ignition wire, which

receives power when the key is turned on.

Red

Yellow

White

Black

AUDIO R (right)

VIDEO IN

AUDIO L (left)

REAR TS

GROUND

ACC

FUSE

Figure 1: Wiring Connections

1 2 3 4 5 6 7 8 9 10

No comments

Audiovox MZ7TFT Specifications Page 3