Audiovox DT 941 CI User Manual Page 44

  • Download
  • Add to my manuals
  • Print
  • Page
    / 48
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 43
г;:?»
i" ;
v^iiriiCASE^FiDIFFIGULTY
-®-
H yau hava difficulty operating your
phone, the suggo^Ucns below should
solve the problem, if you still have
difficulty after trying these
suggestions, call AUDIOVOX
COMMUNICATIONS at [SOO) 229
1235.
THE PHONE DOESN'T WORK AT
ALL
* Make sure tha Power Cord is
pugged
Make sure the telephone line
cord is plugged liimly into the
base unit and the telephone waif
jack.
* Make sure the batteries are
properly charged. If the "LOW
BATTERY" message is shown, the
bahery pack needs charging.
NO DIAL TONE.
' First check all the suggestions
above.
* It you still don't hear a dial tone,
disconnect the base unit from the
telephone jack and connect a
different phone, tf there is no dial
tone on that phone either, the
problem Is in your wiring or lcx:al
service. Call your focal telephone
company.
YOU GET NOISE, STATIC, OR A
WEAK SIGNAL EVEN WHEN YOU'RE
NEAR THE BASE UNtT.
> Household appliances plugged
into the same circuit as the base
unit can sometimes cause
interference. Try moving the
appliance or the base unit to
another outlet.
YOU GET NOISE, STATIC,|oR A
WEAK SIGNAL WHEN'^YQUORE
AWAY FROM THE BASE^ USITk . . i
* You may he out of range. Either
move close to the base, or relocate
the base unit.
The layout of youf home may be
limiting Ihe range. Try moving the
base unit to another position.
THE HANDSET DOES NOT^ RING
WHEN YOU RECEIVE A CAUL
Make sure you have the handset
ringer activated. To set the finger,
see 'PROGRAMMING THE
RINGER'.
' Make sure the telephone line
cord is plugged firmly into the
base unit and the telephone jack.
Make sure Ihe power cord is
plugged in.
You may be too far from the base
uriiL
- You may have too mahy sidension
phones on your telephone line to
allow all of them to ring. Try
unplugging sorna of the other
phones,
YOU HEAR OTHER CALLS WHILE
USING YOUR PHONE,': J , L_
* Disconnect your base unit from
the telephone jack, and plug In a
regular telephone. If you still hear
ether calls, the problem is probably
in your wiring or local service. Call
your focal telephone company.
YOUHEARNOISEINTHE H Af^ DSET,
AND NONE OF 'THE; KEYS OR
BUTTONS WORK. i r!
Make sure the power cord is plugged
in.
Л2
dt»4i« p«i
WIWM.
Page view 43
1 2 ... 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments