Audiovox ACAB104 Installation Manual download pdf (Page 11)

Mounting the Control Module

Determine a dry place inside the vehicle (out of the way) to mount the control

module (e.g., behind an inner body panel), making sure that all wiring will

reach the intended location.

1. Plug the sensor wires, speaker and power harness into the control

module before mounting. The sensor must be plugged into the

corresponding socket (see Figure 4). The control module is pre-fitted

with Velcro for mounting.

2. The Sensitivity Adjustment (E) setting controls the sensitivity of the

sensors. The unit is shipped in the high setting. To lower the

sensitivity, pull the jumper off the middle/right post and place it over

the left/middle post.

3. Clean the pre-selected mounting area to ensure good adhesion.

4. When the surface is dry, peel the backing off the Velcro pad and

attach the control module.

Figure 4

Power cable

Speaker cable

Sensitivity Adjustment(E)

Sensor

Low

High

1 2 ... 6 7 8 9 10 11 12 13 14

No comments

Audiovox ACAB104 Installation Manual Page 11