Audiovox ADV10A Installation Guide download pdf (Page 5)

9. USB Update Cable: This is used for map updates. Route the cable from the

module to the glove box for future use as needed. Connect to the Nav module.

10. GPS Antenna: The antenna must be mounted in a location where it has a clear view of the sky. Center of the dash by the glass is

recommended.

NOTE: If reception is poor re-locate to another area and re-test. The GPS antenna cannot be blocked by metal surfaces

and should be visible for best reception.

11. Nav activation switch: In Cadillac vehicles with CUE, the nav is activated by pressing the NAV icon on-screen. In other vehicles

the nav will be activated by pressing a set position on the screen or using the included wired switch. If using the switch nd

a proper location for the switch to be mounted and then route the wire to the Nav Module. Note: The switch also allows

switching through the AUX inputs if they are utilized.

DIP Switch Settings:

Up is OFF; Down is ON for Dip Switches.

12. Check the DIP Switch settings:

Dip 1: UP External RGB input-Not Used

Dip 2: UP Video Input 1 O

Dip 3: UP Video Input 2 O

Dip 4: DOWN High Resolution On for OEM Screen

Dip 5: UP On for OEM Camera, O for after market camera

Dip 6: UP Not used.

Dip 7: UP Up 8” screen, Down for 4” screen

Dip 8: UP Up 8” screen, Down for 4” screen

13. Check to be sure the Map SD Card is installed in the Navigation unit.

Double check all connections, and then reconnect the vehicle battery.

1 2 3 4 5 6 7 8 9

No comments

Audiovox ADV10A Installation Guide Page 5