Audiovox CCDF User Manual download pdf (Page 9)

128-6951

9 of 12

Angle Flush Mount Installation:

1. Select a suitable mounting location in the rear center of vehicle. Check

behind panel for wire routing access and confirm that the drill will not

damage any existing components. Drill four 1/8” positioning holes and one

7/8” mounting hole at the mounting location according to the drawing of

Size of Mounting Holes.

2. Screw the lock nut (# 3) and the flat washer 2 (# 7) with the non-threaded

side to the camera neck in the showed direction.

3. Mount the slant washer 2 (# 9) to the interior mounting surface.

4. Place the camera neck through the pervious drilled hole with the lens ex-

posed. Then place the slant washer 1 (# 8) to the exterior mounting surface.

5. Tighten the top cover (# 5) towards the camera body.

6. Hold the top cover (# 5) by hand and tighten the lock nut (#3) towards the

topcover (# 5) with the camera cable downwards.

7. Route the camera cable thru an existing grommet into the vehicle.

8. Connect the camera cable to the extension cable and route towards the

monitor.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Audiovox CCDF User Manual Page 9