Audiovox XRO9100 Owner's Manual download pdf (Page 8)

128-8261

8 of 24

Page 8

7. Within 10 seconds, begin to press and release the pushbutton switch to set

the units digit.

(As per the example, press and release 2 times to set the units digit to 2).

8. Turn the ignition switch to the off position. Immediately observe the LED flash

pattern.

You will note the LED flashing five times, pause, and then flash two times, pause.

This pattern will be repeated three times indicating the new code (52) has been

accepted and stored in memory.

NOTE: If after step 7, the LED flashes a code other than what was just entered,

this indicates that the code has not been changed. You will have to repeat

steps 1 through 7 above being certain to note the following:

Acceptable digits 10ths or units are 1 through 9. The unit will not recognize a 0

(Zero), or no digit entered in any place, units or tenths.

NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for

more then 5 seconds during any of the above steps, the unit will revert

back to the last successfully stored code.

MANUALLY OVERRIDING YOUR SYSTEM:

USING THE CUSTOM CODE OVERRIDE

Assuming the override code programmed has not been changed, and the default

override code of 11 is in the system's memory.

1. Enter the vehicle and turn the ignition switch to the on position.

NOTE: The siren will sound.

2. Within 5 seconds, press and release the pushbutton switch 1 time.

3. Within 5 seconds, turn the ignition switch off then on.

4. Within 5 seconds, press and release the pushbutton switch 1 time.

5. Turn the ignition switch off then on and start the vehicle.

NOTE: If you have changed the programmed override code then substitute your

new code tenths for step 2 above, and units for step 5 above.

PUSHBUTTON SAFETY CONTROL SWITCH

The Pushbutton control switch allows you to temporarily disable the remote starting function

of the system. This is recommended whenever the vehicle is being serviced. To place the

system in the service mode:

1) With the system disarmed/unlocked, and the ignition switch off Press and Hold the

pushbutton Switch on.

2) Turn the ignition switch on, off, on, off, on, off.

3) The LED begins to flash two short flashes followed by one long flashes and

continues this pattern until returned to normal mode of operation.

This puts the unit into the R/S Override mode indicating that the remote start is in the

service mode and will not start from RF or any other input Posse or otherwise.

To Exit R/S Override Mode:

1) With the system disarmed, Press and Hold the Push Button Switch on.

2) Turn the ignition switch on, off, on, off, on, off.

3) The LED turns off indicating that the R/S unit is fully functional one again.

ELIMINATING THE NORMAL ARM / DISARM CHIRPS

As explained earlier in the manual, you can eliminate the chirps selectively any

time you arm or disarm the system, if the feature has been activated, simply by

holding the ARM or DISARM button for two seconds. If you find the normal arming

and disarming chirps annoying, they can be turned off permanently, eliminating

the need to hold the ARM / DISARM button for 2 seconds. To do this:

1. Turn the ignition key on then off.

2. Within 10 seconds, press and release valet switch three times.

3. If the chirps were on before you started, then you will hear two chirps indicat

ing they have been turned off.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comments to this Manuals

No comments

Audiovox XRO9100 Owner's Manual Page 8

Comments to this Manuals

Related products and manuals for Car alarm Audiovox XRO9100