Installation GuideVOD12212.1" OVERHEAD LCD MONITORWITH DVD PLAYER®
81) Make the connections to the vehicle for the 12 pin wiring harness.2) Connect power harness to vehicle’s electrical system by tapping into an acces
9VOD122Figure AANT.INRF OUTOUTFUSEDC INRed RCA (Audio Right)Clean the IR Receiver Window on the front of the VCP. Remove Adhesive Backing and Apply I
10CONNECTING THE DOME LIGHTSThe dome lights in the video monitor require three connections to the vehicle's wiring. There are two common types of
11Negative Switched Dome LightingRed / black - Lamp onTo 12 pinconnectorToconstantToconstantBlack / red - Lamp commonPurple / brown - Lamp AutoFactory
© Copyright 2006 Audiovox Electronics Corp. 150 Marcus Blvd. Hauppauge, NY 11788128-7664WWW.audiovox.comFor Customer ServiceVisit Our Website AtProduc
An LCD panel and / or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is use
1TOOLS REQUIRED:#2 Phillips Screwdriver#1 Phillips ScrewdriverUtility or Razor Knife or ShearsWire StrippersUpholstery hook tool (for removal of panel
2Installing The Snap On CoversBegin by hooking area “A” (above) over the dome light and slide the cover over the pod. The cover will snap in place.Pla
31 2 36574Work on a soft surface to avoid damaging the plastic.Insert the supplied pry tool between the Housing and Snap On Cover (Shroud), then press
4VEHICLE PREPARATION:1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off), and also a good gro
5GENERAL SYSTEM CONFIGURATIONS:The following is intended to provide some of the system configurations that are possible with the VOD122Dro
6TRIM RING INSTALLATION:Note: This page only covers special installation considerations for thick trim ring installation. If the video monitor is to b
7MOUNTING THE TRIM RINGRoofRoof SupportHeadlinerMounting BracketSelf-drilling ScrewsTrim RingVideo UnitM5 Screw
Comments to this Manuals