Audiovox VE560 Operations Instructions download pdf (Page 12)

J. Battery Installation

a. Turn the Remote Control face down. Press the ridged area of the battery cover

and slide it off in the same direction as the arrow.

b. Install two AAA batteries. Make sure that proper polarity (+/-) is observed.

c. Slide back the cover in the contrary direction as the arrow until it clicks.

K. CHANNEL TUNING SET UP

In addition to normal broadcast reception of VHF and UHF channels, if you are a

Cable TV subscriber, your new TV is capable of receiving many unscrambled

Cable channels without the use of a converter box. When set to Broadcast TV it

receives CH2-CH69. When set to one of the CATV modes (STD, HRC, or IRC) it

receives CH1-CH125. Follow this simple procedure to make channel tuning more

convenient.

1. Use the TV/CATV button on the Remote Control to select the broadcast or

cable system appropriate for your home. The system selected will be displayed

on the screen. If you have an external roof mounted or rabbit ear antenna,

select “TV,” if you have CABLE TV, select either “STD”, “HRC” or IRC (“STD”

is used by the majority of Cable Systems. Check with your cable system

operator).

2. Press the AUTO MEMORY button on the Remote Control Unit or the TV.

You will see the TV cycle through all channels. The built-in Microprocessor

will automatically store each channel that is actively broadcasting in your

area.

3. To view only strong clear channels, press the SKIP/SEARCH button on the

Remote Control Unit until “SKIP MODE ON” is displayed on the bottom of

the screen. The TV will now tune only to strong, active channels, when the

UP or DOWN buttons are used on the monitor or remote control.

To view a weak or marginal channel, press the SKIP/SEARCH button on the

Remote Control Unit until “SKIP MODE OFF” is displayed on the bottom of

the screen. Tune to the desired channel using the CHANNEL UP/DOWN

button or go directly to the channel by direct access using the 0-9 buttons on

the Remote Control.

4. To ERASE a channel, press the ERASE/WRITE button on the Remote Control

Unit until “MANUAL MEMORY XX ERASE” is displayed on screen. To

STORE a channel, press the button until “MANUAL MEMORY XX ADD” is

displayed on screen.

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Audiovox VE560 Operations Instructions Page 12