Audiovox ACC-52 User Manual download pdf (Page 6)

PROCEDURE FOR HORIZONTAL INSTALLATION

INSTALLATION

The unit can be installed horizontally, vertically or at a 45° angle. The position of the built-in anti-vibration springs (left and right

side), must correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen,

the anti-vibration compensation will not be effective and vibration may cause the disc to skip.

CAUTION: After setting the built-in anti-vibration springs, place the supplied Seals (B) over the holes. These seals are used

to keep dust, which could cause a malfunction, out of the unit.

position "H"

position "V"

HORIZONTAL INSTALLATION

Set the left and right anti-vibration

springs to position "H".

VERTICAL INSTALLAITON

Set the left and right anti-vibration

springs to position "V".

45° ANGLE INSTALLATION

Set the left and right anti-vibration

springs to position "45°".

Drill holes 4mm in diameter.

Attach bracket (L) and bracket (R) to each side of the unit,

using the hexagonal bolts with washer base (M5 x 10)

Determine the mounting location, and drill four mount-

ing holes.

Secure the unit in place, using four self-tapping screws

(M5 x 12).

Use RTV (silicone sealer) on screw threads or around

the holes to prevent moisture intrusion.

Never mount the unit near the fuel tank.

Bracket (R)

Bracket (L)

Hexagonal bolt (4)

with washer base (M5 x 10)

Anti-vibration

springs position

NOTE: Use seals (A) to cover unused

mounting holes on sides of unit.

position "45°"

45°

Bracket (R)

Self-tapping screw (M5 x 12)

Bracket (L)

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

No comments

Audiovox ACC-52 User Manual Page 6