Audiovox HOME BASE DPF711K User Manual download pdf (Page 10)

INSTALLATION (cont’d)

Wall Mount Installation Using the Angle Mount Brackets

NOTE: It is not recommended that you use the foam adhesive pads when mounting the angle mount brack-

ets to a wall surface; in this case, always use screws.

1. Position the mounting template against the wall at the desired location; level the top of the tem-

plate, and mark the position of the two lower holes onto the wall.

2. Using a 1/4” (6mm) drill bit, drill two holes where you marked the wall; if a wall stud is not present,

insert the provided plastic anchors into the holes until they are flush with the wall.

3. Align each angle mount bracket with its respective drilled hole and/or wall anchor; insert a flat-

head screw (two provided) through each wall bracket, and secure the bracket to the wall.

4. Connect the power adapter plug to the DC input connector at the rear of the homebase.

5. Determine how best to route the power adapter wire in reference to the AC wall outlet – to the left

or right side of the homebase – and slip the DC wire into the corresponding wire notch on the back

of the unit.

6. Check the amount of wire required to reach the AC outlet; spool any excess wire onto the four posts

inside the rear hollow of the homebase.

7. Attach each angle mount bracket to the homebase by lining up the individual angle mount bracket

upper mounting tab with its corresponding hole on the homebase.

8. Cover the power adapter wire with either the clear, black or white wire cover; seal the cover using

the double-sided tape provided, and then press into place, adhering it onto the wall surface.

DPF711K

Mounting Hole

Template

Plastic Wall Anchor (2)

if Needed

Drill 1/4” Hole

(2 Places)

Angle Mount

Bracket (2)

Angle Mount Bracket

Mounting Tabs

Flat-Head Self-Tapping

Screw (2)

Wall Surface

HB-711-OM-128-8270-Eng.qxp 6/5/08 9:37 AM Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

No comments

Audiovox HOME BASE DPF711K User Manual Page 10