Audiovox PSS100 - Standard Rear Only System Installation Manual download pdf (Page 11)

Specifications

Power Supply DC9V-DC16V

Current Draw <120mA

Detecting Distance 0ft – 5ft

Sensor Cable Length 19.68ft (6M)

Operating Temperature Range -0°F ~ 176°F

Maintenance

Though your backup system requires minimum care, you should maintain its

condition and performance using the following the guidelines:

• Keep the control box away from moisture, extreme heat or cold.

• Keep the sensors free from snow, ice, and debris.

Diagnostics / Trouble Shooting

Problem Solution

No sound when reverse gear is

engaged.

1. Check if ignition/reverse light on

2. Check power cable connection

3. Check switch on speaker

1 Beep System is functioning correctly

2 Beeps 1 sensor is disconnected/damaged

3 Beeps 2-3 Sensors are disconnected/damaged

4 Beeps No sensors are connected

System beeping without

obstacle behind vehicle

1. Ensure sensor is mounted upright.

2. Remove anything mounted on the

vehicle that may be in the detection

area.

3. Ensure correct hole size has been

drilled in bumper.

4. Verify sensor is installed at the correct

height.

5. Verify sensor is in the correct position.

6. Check all connections.

7. Ensure module is not mounted near

electrical components with high

current.

8. Verify supporter was used if required

(angled/metal bumpers).

1 2 ... 6 7 8 9 10 11 12 13

No comments

Audiovox PSS100 - Standard Rear Only System Installation Manual Page 11