Audiovox AS 9075 User Manual

Model AS 9075Installation ManualRemote Start Upgrade ModuleInstallation InstructionsThis Unit Is Intended For Installation In Vehicles With12 Volt Neg

10The parking lights will flash a number of times indicating the reason for the last remote start shutdown. Thelight flash indications are as follows:

11TESTING YOUR INSTALLATION:CAUTION!! The following procedure must be performed after the installation of an Audiovox Remote StartDevice. It is the re

ignition switch side of the Neutral Start Switch. If the vehicle you are working on does not have an ElectricalNeutral Safety Switch, it will be neces

margin of safety and will prevent the vehicle with a Mechanical Neutral Start Switch from starting in gear.AUDIOVOX ADVISES THAT YOU MAINTAIN THE FACT

METHOD 2To connect to the key in sensor circuit as shown for method 2:A. Locate the control wire that connects the drivers door pin switch to the key

WIRING THE CONTROL MODULE15© 1998 Audiovox Corp., Hauppauge, N.Y. 11788 Form No. 128-5365A2nd White

The AS-9075 Remote Start/Keyless Entry System is designed to be used with Automatic TransmissionVehicles Only! The unit provides a selectable ignition

Remote Start ConnectionWIRING THE 6 PIN MAIN POWER HARNESS:RED w/ WHITE Trace Wire: + 12 volts Battery 1 SourceConnect this wire toa+12VDCconstant sou

BLUE Wire: Ignition 1 OutputConnect this wire to the ignition 1 wire from the ignition switch. This wire will show +12 volts when the ignitionkey is t

the Black w/ White wire is at open circuit through the control switch, the remote starter is disabled.Connect the Black w/ White tracer wire to one of

This wire should be connected to the ignition input of the alarm system.The Yellow w/ Black wire output will allow you to remote start the vehicle whi

NOTE: These wires are typically White w/ Black trace and Violet w/ Yellow trace, however in later modelCadillacs, they are run through an orange sleev

8WIRING THE 4 PIN AUXILIARY OUTPUT HARNESSThe auxiliary 4 pin connector provides low current outputs to control various functions in the vehicle durin

9NOTE:1) When selecting Diesel operation, (Feature Five), over gasoline, the only change is to the ignition 1 circuit.When Diesel is selected, the ign