Audiovox VM9216BT Installation Manual download pdf (Page 2)

VM9216BT

Disconnecting the Battery

To prevent a short circuit, be sure to turn o the ignition and remove the negative (-) battery cable prior to installation.

NOTE: If the VM9216BT is to be installed in a car equipped with an on-board drive or navigation computer, do not

disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use

extra caution during installation to avoid causing a short circuit.

Pre-installation

1. Remove the four screws that attach the mounting sleeve to the

radio and remove the sleeve.

2. Install the mounting sleeve:

a. Install mounting sleeve into the dashboard or optional adapter.

Do not force the sleeve into the opening or cause it to bend

or bow.

b. Locate the series of bend-tabs along the top, bottom and sides

of the mounting sleeve. With the sleeve fully inserted into the

dashboard opening, bend as many of the tabs outward as

necessary so that the sleeve is rmly secured to the dashboard.

c. Install the support strap to make the unit more stable.

3. Place the radio in front of the dashboard opening so the wiring can

be brought through the mounting sleeve.

CAUTION! Be careful not to damage the car wiring.

TAB

DASHBOARD

TAB

ECT

INPU

1 2 3 4

No comments

Audiovox VM9216BT Installation Manual Page 2