Audiovox 50-0246x-015 Series User Manual download pdf (Page 5)

6. Using the diagram in Figure 6, construct a jumper

harness that will connect the vehicle’s dome light

wire harness to the new dome lights in video

system. Make sure that lights in video system

operate from the door jamb switch.

7. Carefully position console against headliner.

Make sure O.E.M. wire harness routes through

opening in console. Loosely install using (2) 6-32

X 3/4" screws (item 4 pg 2) through the smaller

holes in bracket on console into threaded clips on

mounting bracket. Using an awl or similar tool,

align the front mounting holes in console with

holes in bracket. Loosely secure using (2) two #

8 x 3/4” O.E.M. screws previously removed. See

Fig. 7. Make sure console alignment is straight

the tighten all screws. Note: Do not overtighten

screws.

Caution: Do not overtighten screws. Use extra support for the console until secured to the vehicle.

Failure to do so may cause damage to console or installed components.

FIGURE 6

FIGURE 7

1 2 3 4 5 6

No comments

Audiovox 50-0246x-015 Series User Manual Page 5