Audiovox FR-1420 User Manual download pdf (Page 9)

-9-

Your FR-1420 has a unique circuit designed to dramatically extend

the life of its batteries. After 10 seconds of inactivity, the FR- 1420

will switch to battery saver mode. While in battery saver mode, the

battery saver mode indicator (

) is present on the display, and

the transceiver will remain ready to receive any incoming transmis-

sions while the battery saver mode is active. Pressing any of the

buttons will exit the battery saver mode and illuminate the display.

Pull out the face plate from the body of the transceiver using the groove

located at the bottom of the speaker grill.

Insert another face plate into the unit and install the two screws in the upper

side of the tray in the battery compartment. Replace the batteries and cover.

CHANGING SNAP-ON FACE PLATE (CONTINUED)

USING YOUR FR-1420

Turning the Transceiver On and Off ( )

Pressing the PWR button (7) for 2 seconds will activate the unit and ( on )

momentarily appears on the display followed by the frequency standby display.

The speaker will sound a beep tone to confirm the transceiver’s activation. To

turn the unit off, simply press and hold the power button for 2 seconds then

release it.

Volume Level

Audio reception volume is controlled by the Up (▲) and the Down (▼) button.

Momentarily pressing either button will increase or decrease the volume level.

The display will indicate “o1” (lowest setting to “o 8” highest setting).

BATTERY SAVER MODE

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Audiovox FR-1420 User Manual Page 9