Audiovox FRS-1000F User Manual

FRS/ WeatherFRS/ WeatherFRS/ WeatherFRS/ WeatherFRS/ WeatherModel:Model:Model:Model:Model: FRS-1000 FRS-1000 FRS-1000 FRS-1000 FRS-1000Base Stati

10allows the unit to revert to standby mode. When receiving an incomingsignal, the received signal strength indicator ( ) will display

11and hold Button for more than 1 second to lock or unlock keypad functions,except PTT and Monitor (L/MON). When the keypad is locked, the ( )i

12CTCSS filters out unwanted transmissions without the same coded squelchtone). To change the CTCSS Sub-channel,- From the FRS standby mode, press th

13Dual Watch ModeThis feature allows you to monitor two channels. While in dual watch mode,the unit will continuously monitor both the primary and d

14When the key tone feature is on, the Bell icon appears steady on thedisplay, and the beep tones sound in response to each button activation.Roger Be

15- From FRS standby mode, press the VOX button; Vo appears steadyand VOX icon and sensitivity level (if VOX is enabled) flashes on thedisplay.- Pre

16CTCSS Scan OperationThis feature will scan all CTCSS codes for a single channel. It will pause toplay any active transmissions then resume scanning

17Weather Band OperationChannel SelectionThis feature provides access to 10 channels within the weather band (7NOAA channels and 3 Canadian marine c

18Additional FunctionsWhen one or more segments of the battery ( ) icon appear(s) flashingon the LCD panel, recharge unit or install new Audio

Warning•Remove the batteries from the transceiver if it is not expected to be usedfor long periods. This will eliminate the possibility of chemicals

NEVER ATTEMPT TO CHARGE ALKALINE OR DRY CELL BATTERIES.WHEN RECHARGING, USE ONLY THE RECHARGEABLE BATTERIESSUPPLIED WITH YOUR TRANSCEIVER. USE OF OTH

20Troubleshooting (Cont.)Weak or no Weak batteries Charge or replace batteriessignal received Channel and privacy Adjust the transceiver’scode not se

Technical Specifications:GeneralFrequency Range: FRS/Weather Refer to frequency chartsFRS Channels 14Privacy Codes 38 for each main channelDimension

22This transceiver complies with FCC regulations for use in the United Statesof America. Use in other countries may be prohibited or restricted by lo

Continuous Tone Coded Squelch System ToneFrequencies (in Hz)CTCSS Freq. Hz CTCSS Freq. Hz1 67.0 20 131.82 71.9 21 136.53 74.4 22 141.34 77.0 23 146.25

Applies to Audiovox Family Radio and General Mobile ServiceProducts.AUDIOVOX CORPORATION (the Company) warrants to the original retailpurchaser of thi

31. Battery CHARGE On/Off Switch2. Liquid Crystal Display (LCD) 3. Alert (ALT) LED (Red)4. Antenna (Retractable)5. Transmit LED (Green)6. Battery Doo

4Model FRS-1000 DISPLAY1. Button (Key) Tone Beep On/Off Indicator: This icon appearswhen the beep key tone is on, and disappears when tone is notin us

510. Weather Mode Indicator: Icon appears steady when weathermode is active; it flashes when weather alert is active in the FRSmode.11. Roger Beep

6The following guidelines will improve performance and provide longeroperating times for the FRS-1000:1. Do not mix old and new batteries.2. Do not mi

The battery charge indicator icon displays the battery charge level when theAC adpter is unplugged. When the AC adapter is connected and in use, thein

8NOTE:To switch between FRS and Weather Band modes, momentarily press theFRS/WX button. To differentiate between operating modes, look for HI orLO in

9Controls:Power On/Off (16) ButtonPress and hold the power on/off button ( ) for at least 2 seconds. You willhear a confirming melody to indicat