Audiovox AA-RS40CS Installation Manual

Model AA-RS40CSInstallation ManualThis Unit Is Intended For Installation In Vehicles With12 Volt Negative Ground Electrical Systems, Gasoline Or Dies

Brake Switch Positive Shutdown DetailStarter Inhibit Wiring DetailBlackWhite/Black10Orange Wire: Ground When Armed OutputThis wire provides a 300 mA

Green w/Orange Trace Wire: Tachometer Input SignalThis wire will continually monitor the engine tach rate while the unit is under power of the Remote

12starting the vehicle and will remain shunted, if active, while running under command of the remote start.If this wire is active when the system is a

13Dark Blue/Black Trace Wire: External Trigger InputThe Dark Blue/Black trace wire allows the remote start unit to be activated from an external sourc

2 Pin LED Harness: (White Connector)The Red & Blue wires loaded into the two pin mini white connector control the anode and cathode of thedash mo

3 Wire Positive Switched Door Lock/Unlock Wiring Detail153 Wire Positive Switched Door Locks:In this application, the Red wire of the two pin harness

16NOTE: Once you've entered the program mode DO NOT allow more than 15 seconds to pass betweensteps, or the programming mode will be terminated.T

17NOTE:1. When selecting Diesel operation, (Feature Nine), over gasoline, the only change is to the ignitioncircuits. When Diesel is selected, the ig

Programming Tach Rate:NOTE: All applications require that tach be programmed.The unit will not operate unless tach is programmed. If an attempt is ma

3. Connect the Yellow wire to a +12 volt ignition 1 source. This wire will have +12 volts with the ignitionin the on and start position and have 0 vo

The AA-RS40CS Remote Start/Alarm System is designed to be used with Automatic TransmissionVehicles Only! The unit provides a selectable ignition cont

20DO NOT RELEASE THIS VEHICLE TO THE CONSUMER UNTIL YOU CONFIRM THEOPERATION OF THE MANUAL SHUT DOWN / ENABLE FEATURE.NEUTRAL START SAFETY TEST:The in

21control switch wiring and the addition of a 4000 series diode. Shown is a typical GM Park/Neutral ECMinput circuit. To connect the Audiovox remot

22METHOD 1Method 1 will allow the safety required for the remote start unit and prevent the vehicle from startingwhile in any gear other than Park or

23METHOD 2To connect to the key in sensor circuit as shown for method 2:A. Locate the control wire that connects the drivers door pin switch to the ke

WIRING DIAGRAM© 2000 Audiovox Electronics Corp. , Hauppauge N.Y. 11788 128-5820

transmitter and feature program modes. The LED should be installed in the dash in an area highlyvisible so that it may be seen from the driver'

4Caution! Do not wire tie the metal bracket to an existing wiring harness as vibration may cause chaffingand shorting damaging the factory wiring. If

5assure that the vehicle cannot start via RF control in any gear selection other than park or neutral.In both mechanical and electrical neutral start

6GREEN Wire: Ignition 2 OutputConnect this wire to the ignition 2 wire from the ignition switch. This wire will show + 12 volts when theignition key

Hood Pin Switch Detail7Purple Wire: (+) Door Trigger InputIf the vehicle's door courtesy light switches + 12 volts when the door is opened, (Some

General Motors VATS By-Pass Diagram8Light Blue Wire: Ignition 3 OutputThis wire provides a 300mA ground output that becomes active 3 seconds before

95. Connect the previously selected resistor from terminal #87 to the second (#2) wire (as shown).NOTE: The above information and following diagram is