Audiovox AS9233ST Owner's Manual download pdf

128-8604

1 of 8

Remote Start Alarm Keyless Entry

Upgrade System

Congratulations on your purchase of this automotive Remote Start / Alarm Keyless Entry

Upgrade System. This system is a state - of - the - art system is designed to arm and disarm

when it receives a lock or unlock command from your existing Factory Keyless Entry

Transmitter. Taking a few moments to read this manual will help to ensure that your vehicle

is protected at all times.

NOTE:

The system has the ability to beep the vehicle's horn, sound a siren, or both. Where a beep

or chirp is mentioned, consider either or both may sound.

Also All functions of the system will be controlled by the factory transmitter, including the start

sequence however for optimum range, it is suggested that the one button transmitter supplied

be used for starting, and unlocking while running under control of the the remote start.

ARMING THE SYSTEM: ( ACTIVE )

1. Turn the ignition key off, exit the vehicle, and close all doors.

2. Press and release the Lock button on the keychain transmitter.

3. The siren and or horn will beep one time, the parking lamps will flash one time,

and the LED found on the glass mounted receiver will begin to slowly flash, indicating that

the system is ARMED.

If the siren/horn sounds 3 chirps, then you have left a door, trunk, or hood lid ajar.

Simply close the opened entry point to provide full protection. If the siren "chirped"

three times, sometime after arming, the exclusive delayed dome light learn circuit

has been programmed and the system detected a open entry point after the

learned delay expired. Again, closing the hood, trunk, or doors will correct the

problem and you do not need to disarm the system to make the correction. If the

siren/horn did not sound when arming, then the chirps have been turned off, and

you should refer to the section titled “ ELIMINATING THE ARM / DISARM CHIRPS “

in this manual.

4. Any time the door lock switch in the vehicle is used to lock the doors while

the ignition key is turned off, the system will immediately arm. To lock the doors

after entering the vehicle, make sure the ignition key is switched on first.

Turning the ignition key on first will stop the system from arming.

ARMING THE SYSTEM: ( PASSIVE )

1. Turn the ignition key off, exit the vehicle, and close all doors.

2. The LED will begin to flash rapidly, indicating that the system

is automatically ( passively ) arming. As an added convenience, the 30

second automatic passive arming will not begin until all doors are closed,

allowing passengers to exit the vehicle at their convenience.

3. In 30 seconds, you will hear a single short chip from the siren, and the vehicle’s

parking lamps will flash one time, indicating that the system has ARMED. At

this time, the dash mounted PRLED will begin to flash slowly, providing a

visualindication that the system is fully armed.

4. It is possible to program the system, that when the alarm is allowed to

automatically passive arm, there will be a 15 second delay after a door is

opened before the alarm will sound. However, if the system is programmed

for instant trigger there will be no delay. Check with your installer for the setting

of this feature.

Model AS9233ST

OWNER’S MANUAL

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - Model AS9233ST

128-86041 of 8Remote Start Alarm Keyless EntryUpgrade SystemCongratulations on your purchase of this automotive Remote Start / Alarm Keyless EntryUpgr

Page 2 - 128-8604

128-86042 of 8Page 2IMPORTANT! When the system is programmed for passive arming, the systemwill always arm, even when the keychain transmitter has not

Page 3

128-86043 of 8within 3 seconds. The alarm will immediately sound, and continue to sound for30 seconds.2. To stop the alarm before the 30 second cycle

Page 4

128-86044 of 82. Within 10 seconds begin to enter tenths digit of override code. (In this ex-ample the code is 11, so press and release the push-butto

Page 5

128-86045 of 82. Turn the ignition switch to the on position.3. Within 10 seconds, press and release the push-button switch found on the receiverassem

Page 6

128-86046 of 8Page 6starting device. A running engine produces dangerous carbon monoxide fumes which can beharmful or fatal if prolonged exposure occ

Page 7

128-86047 of 82. Shut off the vehicle using the keychain transmitter by pressing and releasingthe remote start transmitter button a second two times i

Page 8 - AS 9233ST

128-86048 of 8AS 9233STSYSTEM FUNCTIONS AT A GLANCEPASSIVE ARMINGARMEDDISARMEDVALET MODEINTRUSION ZONE 3INTRUSION ZONE 2INTRUSION ZONE 1ARMDISARM