Audiovox TERK SIR4 User Manual download pdf (Page 10)

Air Dam Shield Mount Installation Continued

10. Install antenna to Air Dam Shield of truck, See Figure 8.

11. Loosen two screws and two hex nuts in U-Bracket assembly. Note: Installation on tubular sur-

face is NOT recommended. Insert Air Dam Shield edge between the U-Bracket Assembly and

Clamp feet. See Figure 9.

12. Tighten clamp screws on U-Bracket Assembly evenly up against the Air Dam Shield to

15 ft-lbs. using the appropriate torque wrench and adapters (1/2” size, hex or open-end

wrench). IMPORTANT: Assure two 5/16” Hex Nuts are not tight at this step.

13. Tighten two 5/16”-18 Hex Nuts securely up against clamp bracket, See Figure 9.

14. Using the appropriate torque wrench and adapters (1/2” size, hex or open-end wrench) torque

5/16-18 Hex Nuts to 4 ft-lbs. (48 in-lbs.).

15. Loosen the 3/8”-16 Hex Nut and pivot antenna until true vertical position is achieved. Re-torque

3/8”-16 Hex Nuts to 12 ft-lbs.

16. Take the cable connector (180 degree connector) NOT the Right-Angle SMB Connector and

hand tighten over the connector on the bottom side of the Antenna Assembly. See Figure 10.

17. Using the 5/16” open-end wrench, tighten the cable connector on the Antenna Assembly

connector.

18. Place the rubber boot over the end of the Antenna Assembly shaft after the cable connector has

been tighten. See Figure 10

19. Route cable into truck cab and connect to satellite receiver. Verify you have satellite broadcast.

Figure 8. Mounting Location

Figure 9. Mounting Location

Figure 10. Cable Connector/

Rubber Boot Connection

1 2 ... 5 6 7 8 9 10 11 12

No comments

Audiovox TERK SIR4 User Manual Page 10