Audiovox PADIN2 Installation Manual download pdf (Page 4)

Installation Guide (cont.)

d) Depending on the angle of the luggage rack, a 10° wedge base may be required

to keep monitors parallel to the floor. (Fig. 10)

e) Drop four 5/16” grade 8 mounting bolts through mounting holes. (from top of

luggage rack down)

f) Place a mounting plate washer, lock washer, and nut on bolt and tighten to 100

In.lbs. This will provide monitor with a solid mounting base.

g) Place a nut, lock washer, and washer on bolt prior to putting mounting bracket in

place. This will aid in setting the optimal viewing angle.

h) If required, place the wedge base in position. Place mounting bracket in position

and assemble washer, lock washer, and nut to hold bracket in position.

i) Slide monitor into position and hand tighten two ¼-20x1” bolts to hold monitor in

position. Adjust hardware combination to achieve optimal viewing position.

(Fig.10)

j) Connect video in/out (6-pin connector) and power (4-pin pigtail). Cut looped

wire. Splice two 14G orange from harness to one 14G orange from pigtail,

connect two 14G black from harness to one 14G black from pigtail, connect two

18G blue/white from harness to 18G blue/white of pigtail.

k) Install remaining ¼-20 grade 8 bolts and tighten all four to 100 in. lbs.

l) Clean four tabs of mounting bracket with a 70% solution of isopropyl alcohol.

m) Place two 1” x 1” and 1” x 2’ pads of “dual lock” velcro on mounting bracket. (Fig.

10)

n) Place padded shroud over monitor assembly and locate position of mating velcro

pad. If a 10° wedge base is used, be sure shroud is flush to all edges prior to

attaching velcro.

o) Clean internal surface of padded shroud with 70% isopropyl alcohol.

p) Place two 1” x 1” and 1” x 2” pads of “dual lock” velcro on padded shroud (as

located in step n) above.

q) If necessary place 10° wedge base over monitor/bracket assembly and push four

pads of velcro together, being sure all four pads are fully engaged with pads on

monitor.

r) Repeat above steps for each additional monitor location.

Figure 1

MIC (-) Black

PTT Red

Microphone Pin View

MIC (+) White

PTT Green

SWITCHCRAFT A4F

CONNECTOR

1 2 3 4 5 6 7 8 9 ... 19 20

No comments

Audiovox PADIN2 Installation Manual Page 4