Audiovox APS-350-A User Manual download pdf

Page 1

Model APS-350-A

Installation Manual

SELECTABLE FEATURES

Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin switch in order

to begin the passive arming sequence.

RF Programmable Features :

Feature Selection 1 Chirp 2 Chirps Default

First 1 Second Door Locks 3.5 Second Door Locks 1 Second

Second Auto Lock On Auto Lock Off Auto Lock Off

Third Auto Unlock On Auto Unlock Off Auto Unlock Off

Fourth Passive Door Locks Active Door Locks Active Locks

Fifth Passive Arm Active Arm Passive Arm

Sixth Voltage Sense Hardwire Hardwire On

Seventh Horn Chirps On Horn Chirps Off Horn Chirps On

Eighth Siren Chirps On Siren Chirps Off Siren Chirps On

To program these selectable features;

Action System Response LED Response

Turn ignition on No response

Flip valet switch on then off 3 times 1 Chirp - LED 1 flash

Within 3 seconds, turn ignition Off Short chirp, then long chirp

First Within 3 seconds, turn ignition On 1 chirp = 1 second door locks 1 Flash Pause...

Press transmitter button 1 to change 2 chirps = 3.5 second door locks

Second Flip valet switch on then off 2 chirps = auto locks off 2 Flash Pause...

Press tranmitter button 1 to change 1 chirp = auto locks on

Third Flip valet switch on then off 2 chirps = auto unlock off 3 Flash Pause...

Press transmitter button 1 to change 1 chirp = auto unlock on

Fourth Flip valet switch on then off 1 chirp = passive locks 4 Flash Pause...

Press transmitter button 1 to change 2 chirps = active locks

Fifth Flip valet switch on then off 1 chirp = Passive Arm 5 Flash Pause...

Press transmitter button 1 to change 2 chirps = Active Arm

Sixth Flip valet switch on then off 1 chirp = Voltage sense on 6 Flash Pause...

Press transmitter button 1 to change 2 chirps = Hardwire

Seventh Flip valet switch on then off 1 chirp = Horn chirps on 7 Flash Pause...

Press transmitter button 1 to change 2 chirps = Horn chirps off

Eighth Flip Valet Switch on then off 1 chirp = Siren chirps on 8 Flash Pause...

Press transmitter button 1 to change 2 chirps = Siren chirps off

Flip valet switch on then off Exit program mode

Turn ignition key off Exit program mode

Note : Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the

programming will be terminated.

1 2 3 4 5 6 7

Model APS-350-A 1
128-5082A 7

Summary of Contents

Page 1 - Model APS-350-A

Page 1Model APS-350-AInstallation ManualSELECTABLE FEATURESNote : When both Passive Arming and Voltage Sensing are selected, you must hardwire the dri

Page 2

Page 2INSTALLATION OF MAJOR COMPONENTSControl Module :Select a mounting location inside the passenger compartment ( up behind the dash ), and secure u

Page 3

Page 3WIRING THE SYSTEMLarge 11 Pin Edge Connector :Red Fused Wire : + 12 VDC CONSTANT BATTERY SOURCEThis wire controls the sensitivity of the voltage

Page 4

Page 42 Dark Green w/ White Trace Wires : ENTRY ILLUMINATIONThe dark green w/ white trace wires provide the entry lighting, and flash the vehicle’s do

Page 5

Page 5Dark Green w/ Black Trace Wire : LATCHING OUTPUT / CHANNEL 3The green w/ black trace wire latches to ground via an independent RF channel from t

Page 6

Page 6Cut the existing unlock wire, and connect the white wire to the slave switch or motor side of the cut wire.Connect the blue wire to the master s

Page 7 - 128-5082A

Audiovox Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788128-5082A