128-93241 of 12Model PRO9233EInstallation ManualFactory Keyless Entry Alarm Upgrade SystemPATENTED: www.voxxintl.com/company/patentsTable Of Contents
128-932410 of 12 Page 10SELECTABLE FEATURESThe selectable features of this unit can be set manually as explained on the previous page.Factory defa
128-932411 of 12 NOTE: The program mode is exited if any of the following occur: a. 15 seconds of inactivity expire during any of the above steps
128-932412 of 12 PRO9233EGreen/Black Arm2Red Disarm 1Green Arm 1Red/Black Disarm 2Blue Trunk ShuntPushbutton LED AssemblyRedGreenRed = (-) Lock (+
128-93242 of 12 Before You BeginPROFESSIONAL INSTALLATION IS STRONGLY RECOMMENDEDRoll down window to avoid locking the keys in the vehicle during inst
128-93243 of 122 Pin Door Lock Output Harness Part #112224214 Pin Main Wiring Harness Part # 11238955 Pin Arm/Disarm Trunk Shunt I/O Harness Par
128-93244 of 12 This system provides an output that is used to drive the siren, and an output that can pulse the vehicle's horn. When utilizing
128-93245 of 12In the AND confi guration, both wires must invert to have a state change at the alarm module to either arm or dis-arm. In the OR confi gu
128-93246 of 12 RED/WHITE : (+) 12 VOLT MODULE's POWERSee RED Wire above. WHITE w/ BLACK TRACE WIRE : POSITIVE OUTPUT TO SIREN This is a + 12
128-93247 of 12Page 7 LIGHT GREEN WIRE : (-) INSTANT TRIGGER ZONE 1This is an instant activation ground trigger wire. This wire should be reserved fo
128-93248 of 12 Page 8the two inputs Arm #1 & Arm #2. If both inputs are active at the same time, the vehicle will not arm. The intent of this w
128-93249 of 12Page 9WIRING THE ARM / DISARM INPUTS IN VEHICLES WHEN THE SYSTEM IS SET UP AS A STAND ALONE PASSIVE (IGNITION CONTROL) ALARM SYSTEM For
Comments to this Manuals