Audiovox VE560 Operations Instructions download pdf (Page 6)

WALL MOUNT INSTALLATION

IMPORTANT!! Do not attempt to install the VE-560 vertically, unless you are

sure that the electric circuits in the chosen area have been turned off at the

fuse or circuit panel. Failure to do this could result in electric shock.

1) For vertical installations, choose a mounting location that is close to eye

level and is in close proximity to an electrical outlet and a TV antenna or

cable connection.

2) Cut out the template provided and temporarily tape it to the wall at the de-

sired location. Mark the center of the vertical mounting slot and remove the

template.

3) Determine if a wall stud is present at the chosen location by drilling a 1/16”

hole at the marked location. CAUTION!! If this unit is to be installed near an

electrical outlet, there is likely to be electrical wiring present.

4) If a structural stud is present, a suitable length drywall screw can be screwed

directly into it. Leave approximately 1/4” of the screw protruding from the

wall.

If there is no structural stud present, a drywall anchor from your local hard-

ware store will be necessary. Remember to leave 1/4” of its screw head

protruding from the wall.

5) Hang the VE-560 onto the screw head using the vertical mounting slot at the

rear of the unit.

6) Plug the male end of the adapter into the receptacle marked DC 12V input

on the bottom of the VE-560 and AC Power adapter plug into a nearby elec-

trical outlet.

8) Connect your TV antenna or cable system to the antenna connector on the

bottom of the VE-560

9) Route the wires safely away from heat and moisture sources and secure

them in place using the self adhesive wire mounting clip provided.

Vertical Mounting

Slot (Rear of Unit)

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

No comments

Audiovox VE560 Operations Instructions Page 6