Audiovox ACC-52 User Manual download pdf (Page 16)

LOADING DISCS INTO THE MAGAZINE

This CD Changer uses a specially-designed magazine to hold

up to 10 compact discs. To load discs into the magazine, grip

the tab on the magazine tray into which you will be loading a

disc and pull it out gently as shown in Figure 1. Pull out only one

tray at a time. Insert a disc into the tray with the label side up

(play surface facing down) as shown in Figure 2. Push the tray

back into the magazine as shown in Figure 3. Load discs into

the remaining 9 trays in a similar manner.

REMOVING DISCS FROM THE MAGAZINE

To remove a disc from the magazine, pull out the tray of the disc

to be removed, lift out the disc, and push the tray back into the

magazine.

USE OF THE CD MAGAZINE

NOTES:

Fig. 3

Fig. 2

Fig. 1

Label side up

Avoid touching the playing side of the disc.

Only one disc can be inserted into each tray of the maga-

zine. Do not try to insert more than one disc into each tray

as damage to the discs and magazine may occur.

This changer is not designed to play 3" CD-Single discs

(8cm). Inserting a 3" disc into the magazine, either with

or without a 3" disc adaptor, can damage the changer and

the disc. Such damage will not be covered by the Warranty

on this product.

Additional CD magazines are available as accessory item

part number ACC-52MAZ from your Audiovox dealer, or

you may contact us directly at:

LOADING THE MAGAZINE INTO THE CHANGER

Completely slide the door on the changer to the right as shown in

Figure 4. Making sure the top of the magazine is facing upward,

gently insert it into the unit until it clicks into place, as shown in Figure

5. Slide the door of the changer fully closed and the unit is ready for

operation.

REMOVING THE MAGAZINE FROM THE CHANGER

The magazine can be removed from the changer using one of two

methods as outlined below in steps 1 and 2.

NOTE: Be sure to keep the door on the changer closed at all times

when not loading or removing the magazine. Leaving the door open

could allow dust, dirt and moisture to enter the changer which could

cause the unit to malfunction.

1. During normal operation with power applied, slide open the

door on the changer and press the eject button as shown

in Figure 6. The magazine will eject and can be removed.

2. If the magazine will not eject in a normal manner, remove

power by disconnecting the DIN cable from the changer.

a. Slide open the magazine door. At the lower left rear of the

changer, as shown in Figure 6, insert a thin-bladed screw

driver straight into the access hole about 1-1/2 inches until

it contacts the release tab.

b. Lightly leverage the blade to the right and the magazine will

disengage and be ejected.

Fig. 6

Fig. 5

Fig. 4

Eject Button

Mechanical Release

Access Hole (Left

Rear)

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Audiovox ACC-52 User Manual Page 16

Comments to this Manuals

Related products and manuals for CD players Audiovox ACC-52