Audiovox PRO-9056 User Manual download pdf (Page 3)

128-7762

3 of 19

To exit program mode, turn ignition off, or press and release valet switch.

RF Programmable Features Bank 3 Is Remote Start Selectable Features:

Feature Selection 1 Chirp 2 Chirps 3 Chirps 4 Chirps 5 Chirps 6 Chirps

1st Defrost Output Not Available

2nd RF Start Chirp Not Available

3rd Run Time 5 Mins 10 Mins 15 Mins 20 Mins

4th Parking Lights On Steady Flashing

5th Input Check Voltage Tach DBI Input

6th Voltage Level >0.5V B4 Start < 0.5V B4 Start

7th Ign. 2 Select Off During Crank On During Crank Same As Accy.

8th Ign. 3 Select Not Available

9th Diagnostics Off On

10th Crank Time 0.8 Sec 1.0 Sec 1.5 Sec 2.0 Sec

11th Gas/Diesel Gas Diesel 10 Diesel 15 Diesel 20

12th Transponder O/P While R/S On During Start Until Ign. Off

13th Temp Start Not Available

14th Crank Averaging Averaging Preset Time Note: When averaging, the engine must be started 4 times with the key to be effective.

15th R/S Shock Not Available

16th Turbo Select Not Available

17th Black/Blue (Aux O/P) Single Pulse As Feature #1Bank 2

Note: When setting feature #17 to operate as feature #1 Bank 1 the transmitter will also control this output only while running under R/S command. So in

other words, if this output is used to unlock the doors with the transmitter, the doors will unlock on startup. To relock the doors, use the After Start Black

Green wire of the 4 pin connector.

When using the RF programmer, enter the program mode as follows:

Turn the ignition on

Press and release valet switch 3 times

turn ignition off then on

Press and hold valet switch for 5 seconds

Siren chirps 2 times indicating access to RF feature program mode.

To exit program mode, turn ignition off, or press and release valet switch.

1 2 3 4 5 6 7 8 ... 18 19

Comments to this Manuals

No comments

Audiovox PRO-9056 User Manual Page 3

Comments to this Manuals

Related products and manuals for For the car Audiovox PRO-9056