Audiovox CCS-100 Service Manual download pdf (Page 27)

Installing the Audiovox CCS100 Cruise Control on the

Honda Pacific Coast PC800 Motorcycle

Page 25

Upward bellcrank, rear-pulling actuator cable, and anchor:

Chain Connections

Locate the "bead chain eyelet connector (#25)" and "slotted head shoulder bolt with lock washer

and hex nut (#34)" from the CCS100 kit. Attach the eyelet to the bellcrank using the shoulder

bolt. Ensure that the bolt, washer, and nut are tightened securely.

Attach the bead chain from the servo actuator cable to the eyelet connector on the bellcrank.

Adjust the attachment point on the bead chain to remove most of the slack from the chain and

actuator cable, but leave a slight amount of sag. Too tight a cable will throw off your idle

adjustment. Fine adjustments to the cable/chain tension may be made with the nuts on the

actuator cable anchor mount. Once the cable/chain tension is correct, securely tighten the cable

anchor nuts. Excess beads may be removed from the end of the chain. Pay attention to the note in

the Cruise Control Installation Manual Insert regarding "safe bead installation requirements";

never have less than 7 beads in the chain. It is also important to ensure that nothing rubs, catches

or chafes the action of the actuator cable and chain.

Reinstall the air box onto the carburetors, attach all connections, and tighten down all clamps.

Make sure that there is no interference between the air box and any of the cruise control parts.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

No comments

Audiovox CCS-100 Service Manual Page 27