128-86131 of 12Page 1Model APS-620NInstallation ManualThis Remote Start System is designed to be used withAutomatic Transmission- Fuel Injection Vehi
128-861310 of 12Page 10The Light Blue wire can be used to accommodate the following situations:A. Shock Sensor By Pass:B. Additional Ignition Output:C
128-861311 of 12Page 11Setting Up The System Programming Features:Bank 1 Transmitter ChannelsStart with the system disarmed, turn the ignition switch
128-861312 of 12Page 124 PIN IN VEHICLE DATA BUS PORT (DBI Port)The 4 pin port located on the side of this module is for proprietary Audiovox data bus
128-86132 of 12Page 2INSTALLATION OF THE MAJOR COMPONENTS:CONTROL MODULE:Select a mounting location inside the passenger compartment (up behind the da
128-86133 of 12Page 3the remote start unit. If the vehicle is being worked on, this hood switch prevents theremote start activation even if the RF c
128-86134 of 12Page 4YELLOW Wire: Starter OutputCareful consideration for the connection of this wire must be made to prevent thevehicle from startin
128-86135 of 12Page 53 Wire Ground Switched Door Lock Circuits:In this application, the Red wire of the 2 pin harness provides a ground pulse during t
128-86136 of 12Page 6Wiring The 4 Pin Auxiliary Output Harness, Connector “A”The auxiliary 4 pin connector provides low current outputs to control var
128-86137 of 12Page 72 Pin Valet/Program/Override Push-Button Switch, Connector “D”The Black & Grey twin lead wires loaded in the two pin blue con
128-86138 of 12Page 83 Pin Antenna/Receiver, Connector “F”Route the 3 pin connector from the previously installed antenna receiver assemble to themati
128-86139 of 12Page 9To test this circuit, while the vehicle is running under control of the remote start unit, openthe vehicle’s hood. The remote st
Comments to this Manuals