Model PRO-9671FTInstallation Manual4 Channel Remote Car StarterWith Full Feature Alarm SystemInstallation InstructionsThis Unit Is Intended For Instal
Orange Wire: Ground When Armed OutputThis wire provides a 300 mA ground output when the alarm circuit is armed to control the starter inhibitrelay. Co
Black Wire: Chassis Ground SourceConnect the Black wire to a known vehicle ground source or to a solid clean metal part of the chassis. Becertain to r
Dark Blue Wire: Delayed 300mA Pulsed Channel 2 OutputThe Dark Blue wire supplies a 300mA ground pulsed output whenever channel two of the receiver is
2 Pin Control Switch: (Red Connector)The Black & Black w/White Trace wires loaded in the two pin red connector enable the operation of theRemote S
3 Wire Positive Switched Door Locks:In this application, the Red wire of the two pin harness providesa+12volt pulse during the disarmingsequence, or p
ALARM SELECTABLE FEATURESNOTE: The Alarm Selectable Features and Remote Start Selectable Features programming steps following are basedon transmitter
REMOTE START SELECTABLE FEATURESRF Programmable Features:LED Pattern1 x Pause etc.2 x Pause etc.3 x Pause etc.4 x Pause etc.5 x Pause etc.6 x Pause et
Multi Coil Pack Adaptor: (Optional)The multi coil pack adaptor is designed for use with vehicles having multiple ignition coils where a singlepoint ta
TESTING YOUR INSTALLATION:CAUTION!! The following procedure must be performed after the installation of an Audiovox Remote StartDevice. It is the resp
CAUTION!REMEMBER TO RECONNECT THE BROWN/BLACK WIRE TEMPORARILYDISCONNECTED IN STEP 3DO NOT RELEASE THIS VEHICLE TO THE CONSUMER UNTIL YOU CONFIRM THE
The PRO-9671FT Remote Start/Alarm System is designed to be used with Automatic TransmissionVehicles Only! The unit provides no output for glow plug pr
KEY IN SENSOR CIRCUITS:If the vehicle you are working on does not have or you cannot locate the ECM reference wire, there are twoalternatives availabl
METHOD 2To connect to the key in sensor circuit as shown for method 2:A. Locate the control wire that connects the drivers door pin switch to the key
OUTPUT GREEN/BLACK (-)TO CHANNEL 3 CONTROL RELAYGREENREDDOOR LOCKS(See page 13)REDBLUEL.E.D.(See page 13)BLUEREDGREENBLACKSHOCK SENSOR(See page 13 &am
drill a 1/4" hole in the desired location and pass the connector end of the LED through the hole and towardthe control module. Press the LED firm
The PRO-9671FT is to be used in vehicles with AUTOMATIC TRANSMISSIONS only! Although thiscombination Alarm/Remote Start unit is a sophisticated system
BLUE Wire: Ignition 1 OutputConnect this wire to the ignition 1 wire from the ignition switch. This wire will show +12 volts when theignition key is t
WIRING CONNECTIONS: Multi Pin Accessory Input/Output HarnessWhite w/ Red Trace Wire: Parking Light Flasher FeedThis wire is the common contact of the
Purple Wire: (+) Door Trigger InputIf the vehicle's door courtesy light switches + 12 volts when the door is opened, (Most Fords and someImports)
General Motors VATS By-Pass DiagramLight Blue Wire: Ignition 3 OutputThis wire provides a 300mA ground output that becomes active 3 seconds before the
Green w/ White trace Wire: Entry Illumination Ground OutputThis wire provides a 30 second ground output (300 mA Max.) whenever the remote is used to d
Comments to this Manuals