Audiovox PADIN2 Installation Manual download pdf (Page 6)

Rear PADIN2 Features

Figure 4

1) MIC Gain- These controls are accessed through the control in rear. The

potentiometer marked GAIN1 sets the level for the MIC jack, and GAIN2 sets

the level for the second MIC jack. These adjustments will be required to

match audio levels of the other sources.

To adjust:

a) Turn the PADIN2 to the “on” position and turn the volume control to half

volume and select Video or Radio on the source select control.

b) Be sure the video or radio source is operational to obtain a reference

level.

c) Connect the hand-held MIC to rear panel.

d) Key the microphone and adjust level to existing audio level produced

by the selected source. Clockwise increases the audio level and

counterclockwise will decrease the level.

2 & 3) Microphone 1 and 2- Microphone input plus adapter will allow operater to

use most available microphones, the appropriate Gain control

potentiometer must be preset per the above instructiions. See Fig. 1 for

microphone and pinout.

4) Speaker Out- This connection goes to both right and left internal and external

speakers. See Fig. 11 for speaker connections

5) Mounting Lugs- Used to level out the radio when mounting.

6) Power- Connector (Amp P/N 172167-1) mates to Amp 171637-1. See wire

color Code and harness layout . (Table 1 and Figure 8)

7) Audio In- Supplies audio from VCP, monitor and radio.

4 5 6

L Int. Spkr (-)

L Int. Spkr (+)

IR (+)

IR (-)

Ext. Spkr (+)

R Int. Spkr (+)Ext. Spkr (-)

R Int. Spkr (-)

+12V

Audio From VCP (+)

Radio Input R (+)

Radio Input L(+)

Monitor Trigger

Ground

Audio From VCP (-)

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

No comments

Audiovox PADIN2 Installation Manual Page 6