Audiovox MZ7TFT Owner's Manual download pdf (Page 6)

VM9022

What’s in the Box

1. Left and Right Double DIN Mounting Brackets

2. Double DIN Half Sleeve Install Bracket

3. Remote Control with Battery

4. Rear Support Mounting Strap

5. iPod Jlink Cable

6. Two Custom Cosmetic Trim Rings

7. Parking Brake Wire

8. MediaLink Box

9. Screen Cleaning Cloth

10. M5x6 and M3x4 Screws to Mount Radio to Brackets

11. Speaker Output Harness

12. Power Input Harness

13. Center Channel Wire Harness

Optional Equipment

• NAV101

The VM9022 is "navigation ready." Before accessing

any navigation features, you must purchase and install

the NAV101 module. All installation and operating

instructions will be included with the NAV101 navigation

module.

Once the NAV101 is connected and operating properly,

the NAV source mode will become active. While the

NAV101 is not installed, the NAV option appears gray,

indicating the function is not available.

• Rear Camera

The VM9022 is "camera ready." Before accessing any

camera features, you must purchase and install a rear

video camera. Once the rear camera is connected and

operating properly, the CAMERA source mode will

become active. While the camera is not installed, the

CAMERA option appears gray, indicating the function is

not available.

• Satellite Radio Tuner

See “Satellite Radio Operation” on page 22.

• jLinkCable and iPod

See “MP3/WMA Operation” on page 29.

• Bluetooth Phone

See “Bluetooth Operation” on page 32.

• 3.5mm to 3.5mm Audio Cable

Sold separately at various retailers.

Tools and Supplies

You will need these tools and supplies to install your

VM9022:

• Torx type, flat-head and Philips screwdrivers

• Wire cutters and strippers

• Tools to remove existing radio (screwdriver, socket

wrench set or other tools)

• Electrical tape

• Crimping tool

• Volt meter/test light

• Crimp connections

• 18 gauge wire for power connections

• 16 – 18 gauge speaker wire

Disconnecting the Battery

To prevent a short circuit, be sure to turn off the ignition and

remove the negative (-) battery cable prior to installation.

NOTE: If the VM9022 is to be installed in a car equipped

with an on-board drive or navigation computer, do not

disconnect the battery cable. If the cable is

disconnected, the computer memory may be lost. Under

these conditions, use extra caution during installation to

avoid causing a short circuit.

WARNING! Only connect the unit to a12-volt power

supply with proper grounding.

WARNING! Never install this unit where operation and

viewing could interfere with safe driving conditions.

WARNING! To reduce the risk of a traffic accident (except

when using for rear view video camera) never use the

video display function while driving the vehicle. This is a

violation of federal law.

WARNING! Never disassemble or adjust the unit.

WARNING! To prevent injury from shock or fire, never

expose this unit to moisture or water.

WARNING! Never use irregular discs.

WARNING! To prevent damage to the mechanism inside

this unit, avoid impact to the TFT monitor.

WARNING! Using an improper fuse may cause damage

to the unit and result in a fire.

1 2 3 4 5 6 7 8 9 10 11 ... 123 124

Comments to this Manuals

No comments

Audiovox MZ7TFT Owner's Manual Page 6

Comments to this Manuals

Related products and manuals for TVs & monitors Audiovox MZ7TFT