Audiovox D2016 - DVD Player - 10.2 Instruction Manual download pdf (Page 48)

Advanced Setup

To get the best bass performance from your speaker sys-

tem, you need to set the crossover frequency according

to the size and frequency response of your subwoofer

and other speakers (front, center, and surround).

Note:

•For a more accurate setting, look up the frequency

response in the manuals supplied with your speakers

and set accordingly. In addition, listen to some music

that you know well and choose a higher crossover fre-

quency if you think there’s not enough sound coming

from the subwoofer; a lower setting if you think

there’s too much.

To get the best from surround sound, it’s important that

the sound from each speaker reaches the listener at the

same time. To achieve this, you need to specify the dis-

tance from each speaker to the listening position.

vance

setup cannot

e set w

hil

ones are connecte

eaker B is on, or the multi channel in

ut is bein

used.

Crossover Frequency

Press the [AMP] button followed

by the [SETUP] button on the

remote controller.

Use the Up and Down [ ]/[ ]

buttons to select “1. SP Conﬁg,”

and then press the [ENTER] but-

ton.

Use the Down [ ] button to

select “Crossover,” and then use

the Left and Right [ ]/[ ] but-

tons to select a crossover fre-

quency.

Choose a crossover frequency suitable

for your setup.

If you’re using a subwoofer,

choose a

crossover frequency based on the diam-

eter of your front speakers.

If you’re not using a subwoofer,

use

the diameter of the ﬁrst speaker that

you speciﬁed as Small in steps 4

through 7 in the “Speaker conﬁgura-

tion” setting.

AMP

ENTER

Speaker cone

diameter

Crossover

frequency

Over 8 in.

(20 cm)

60Hz

6-1/2 to 8 in.

(16–20 cm)

80Hz

5-1/4 to 6-1/2 in.

(13–16 cm)

100Hz (default)

3-1/2 to 5-1/4 in.

(9–13 cm)

120Hz

Under 3-1/2 in.

(9 cm)

150Hz

Press the [SETUP] button.

Setup closes.

Speaker Distance

Measure and make a note of the

distance from each speaker to

the listening position.

Press the [AMP] button followed

by the [SETUP] button on the

remote controller.

Use the Up and Down [ ]/[ ]

buttons to select “2. SP Dis-

tance,” and then press the

[ENTER] button.

Use the [DISPLAY] button to

switch

ft:

distances in feet. Can be set from

1 to 30 feet in 1-foot steps.

distances in meters. Can be set

from 0.3 to 9 meters in 0.3-meter

steps.

AMP

ENTER

DISPLAY

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 59 60

Comments to this Manuals

No comments

Audiovox D2016 - DVD Player - 10.2 Instruction Manual Page 48

Comments to this Manuals

Related products and manuals for AV receivers Audiovox D2016 - DVD Player - 10.2