10MOUNTING THE TRIM RINGRoofRoof SupportHeadlinerMounting BracketSelf-drilling ScrewsTrim RingVideo UnitM5 Screw
11VOD128A1) Make the connections to the vehicle for the 12 pin wiring harness.2) Connect power harness to vehicle’s electrical system by tapping into
VOD128A12DIN 1Figure A * Optional Relay BoxSIRSWB9 Pin ~ 3 RCA Jack PigtailLine Out-R (Red)Line Out-L (White)Line Out-V (Yellow)Dome LightPower source
CONNECTING THE DOME LIGHTSThe dome lights in the video monitor require three connections to the vehicle's wiring. There are two common types of d
Troubleshooting:14Negative Switched Dome LightingRed / black - Lamp onTo 12 pinconnectorToconstantToconstantBlack / red - Lamp commonPurple / brown -
8128-8354A
An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicl
3MATERIALS INCLUDED IN THIS PACKAGE:1) 12.1” LCD Overhead Monitor With DVD Player – (1pc)2) 12 Pin Power / Signal Harness (P/N 112-3483) – (1pc)3) 2 P
4Installing The Snap On CoversBegin by hooking area “A” (above) over the dome light and slide the cover over the pod. The cover will snap in place.Ins
54Work on a soft surface to avoid damaging the plastic.Insert the supplied pry tool between the Housing and Snap On Cover (Shroud), then press the pry
6GENERAL INSTALLATION APPROACH:1) Decide upon system configuration and options that will be installed (i.e.: what components, VCP, Video Game, externa
7VEHICLE PREPARATION:1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off), and also a good gro
8GENERAL SYSTEM CONFIGURATIONS:The following is intended to provide some of the system configurations that are possible with the VOD128A Drop Down Vid
9TRIM RING INSTALLATION:Note: This page only covers special installation considerations for thick trim ring installation. If the video monitor is to b
Comments to this Manuals