Audiovox AOM-713WP Specifications Page 50

  • Download
  • Add to my manuals
  • Print
  • Page
    / 65
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 49
50
REAR BODY REFELCTIVE CHEVRON STRIPING
The rear-facing vertical surfaces of the rear taillight panels and the rear body area beside the full
height rear door(s), visible from the rear of the apparatus, including the rear compartment door(s),
shall be equipped with six (6) inch wide retro-reflective striping in a chevron pattern sloping
downward and away from the centerline of the vehicle at an angle of 45 degrees.
Each stripe in the chevron shall be a single color alternating between red (3M #-82) and yellow
(3M # -81).
BODY RUBRAIL - POLISHED STAINLESS STEEL
The apparatus body shall have a bolt on extruded, polished stainless steel rub rail affixed to the side
beneath each door area. The rub rail shall provide additional strength and protection and shall be
constructed of 3/8" x 1-1/2" stainless steel fastened with stainless steel fasteners. Each rub rail
shall be attached to the apparatus body with stand off
STAINLESS STEEL APPARATUS BODY PAINTED
The following apparatus body components shall be painted Red to match the cab lower color.
The rear wheel fender panels
The exterior surface of the coffin compartments
The area between the doors on the side compartments
EXTERIOR COMPARTMENT LIGHTING
A minimum of four incandescent compartment lights shall be provided for each body compartment.
No exceptions to this requirement.
Two (2) LED strip lights shall also be provided for each body compartment in addition to the
incandescent compartment lights.
Each body door shall have an automatic compartment light switch.
UNDERBODY LIGHTING
Underbody ground lights shall be provided under the apparatus body as required by current NFPA
1901. Four Truck-Lite model #60 ground lights shall be provided at the rear of the apparatus body,
two each side, to illuminate under the rear compartments.
There shall also be four model #40 ground lights provided two (2) at the outer front corners of the
apparatus body, one (1) each side, to illuminate the area under the forward compartments and two
(2) below the middle full height compartments, one each side. All underbody ground lights shall be
switched on when the parking brake is set ignition and master battery switch in the "ON" position.
CAB SIDE SCENE LIGHTS
There shall be one side scene lights installed on the left & right sides of the cab between the front
and rear cab doors on the raised roof section. The lights shall be Whelen M6ZC white LED Scene
lights mounted on Whelen M6P15C 15° angled bright finished housings. The scene lights shall be
operated by a switch located in the driver's area of the cab. The scene light shall also be
automatically operated by either the front or the rear door on the same side of the cab opening.
Page view 49
1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 64 65

Comments to this Manuals

No comments