Audiovox XR9 - XM Radio Tuner Owner's Manual download pdf (Page 6)

IRLinc Transmitter Owner’s Manual

Page 6 of 15

Installing IRLinc Transmitter

1) Plug the IR emitter plug into the IRLinc emitter jack

2) Plug IRLinc into a convenient, unswitched wall outlet near your IR equipment

HINT: You will need access to the bottom of IRLinc during Linking so you may want to temporarily

use an extension cord until setup is complete.

The IRLinc Status LED will turn on solid blue

3) Locate the IR sensor for the IR-controlled device you would like to control

NOTE: When using the stick-on emitters, it is important to find the IR sensor on the equipment and

place the emitter directly over the sensor. Use a flashlight to look into the display or bezel of the

equipment to find the sensor. If the sensor is too difficult to find, you can partially cover the front of the

equipment with an object or thick cloth. If the remote works, then continue to isolate areas of the

uncovered section to narrow down the location of the sensor.

4) Once you have located the device’s IR sensor, hold the emitter where you intend to mount it and then

learn and test the IR code

a) Double-tap the Set button on IRLinc

IRLinc will double-beep and its Status LED will begin blinking

b) Point your IR remote control at the bottom of IRLinc, holding it within a couple inches of the

IR sensor. Then, tap the IR button to be learned.

IRLinc will double-beep and its Status LED will turn on solid

If IRLinc beeps eight times, remount the IR emitter and start over from step a

c) Test that the IR code has been learned by tapping the Set button on IRLinc

IRLinc will beep

5) Remove the peel-off backing from the first IR emitter and mount it over the IR sensor

6) Repeat steps 4 and 5 for the second IR emitter

NOTE: Due to heat build-up and the potential for causing damage to this device, it is strongly

recommended that you avoid using the front pass-through outlet for stacking INSTEON devices. Also

avoid using this pass-through for other heat-generating power supplies.

See a tutorial video at: www.smarthome.com/videos/2411T.wmv

USING IRLINC TRANSMITTER

INSTEON

IRLinc responds only to INSTEON ON or OFF commands. ALL ON/OFF or BRIGHT/DIM commands are

ignored.

NOTE: For any given INSTEON Controller button, the IR commands associated with the ON command

are independent of the IR commands associated with the OFF command, for added flexibility.

X10

IRLinc responds to the X10 addresses which are programmed and not the commands. For example, if

you program A1, IRLinc will respond to any command which starts with A1, such as A1 ON, A1 OFF, etc.

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

No comments

Audiovox XR9 - XM Radio Tuner Owner's Manual Page 6