Audiovox XR9 - XM Radio Tuner Owner's Manual download pdf (Page 7)

IRLinc Transmitter Owner’s Manual

Page 7 of 15

CONTROLLING IRLINC TRANSMITTER FROM AN INSTEON

CONTROLLER

Linking an INSTEON Controller to IRLinc Transmitter

To control your IR devices from an INSTEON Controller, follow these steps to Link IRLinc and the

Controller together. Refer to your Controller’s Owner’s Manual for detailed instructions on how to properly

install and Link it to IRLinc Transmitter.

The following will work for the most common INSTEON devices:

1) Set the Controller to Linking Mode. (For most Controllers, press & hold an On or Scene button for 10

seconds or the Set button for 3 seconds.)

You will have 4 minutes to complete the next step before Linking Mode automatically times out.

2) Press & hold the Set button on IRLinc until it double-beeps (3 seconds)

After a few seconds, IRLinc will double-beep again. DO NOT PROCEED UNTIL YOU HEAR

TWO SETS OF DOUBLE-BEEPS.

3) OPTIONAL: If you want to send the IR code to respond to an OFF command instead of an ON

command, send an OFF command from the Controller within 30 seconds of performing step 2

NOTE: Sending an OFF command in this step will not affect any other Link.

If an OFF command is sent, IRLinc will double-beep

4) Confirm that Linking was successful by tapping the button you just Linked to on the Controller

IRLinc will respond appropriately

Unlinking IRLinc from an INSTEON Controller

If you are going to discontinue using IRLinc, it is very important that you Unlink it from any Linked

Controllers. Otherwise, the Controller will retry any commands repetitively, thus slowing down the system.

The following will work for the most common INSTEON devices:

1) Set the Controller to Unlinking Mode. (For most Controllers, press & hold an On or Scene button for

10 seconds twice or the Set button for 3 seconds twice.)

You will have 4 minutes to complete the next step before Unlinking Mode automatically times out.

2) Press & hold the Set button on IRLinc until it double-beeps (3 seconds)

After a few seconds, IRLinc will double-beep again

3) Confirm that Unlinking was successful by tapping the buttons you just Linked from on the Controller

IRLinc will no longer respond

CREATING AN INSTEON SCENE

INSTEON scenes let you activate dramatic lighting moods with the press of just one button. For example,

you can set all the lights in a scene to dim to 50% or turn certain lights on while turning others off, all with

the tap of a button on a Controller.

INSTEON scenes are very easy to set up – just Link more than one Responder to the same On/Off or

Scene button on a Controller. Then, when you press any of the Linked buttons on the Controller, all of the

INSTEON devices Linked in the scene will respond as a group.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Audiovox XR9 - XM Radio Tuner Owner's Manual Page 7